Advertisement
Quick Links
Advertisement
Related Manuals for Whirlpool AKR3200/IX
Summary of Contents for Whirlpool AKR3200/IX
- Page 1 INSTRUCTION MANUAL Decorative Hood AKR3200/IX...
- Page 2 CONTENTS RECOMMENDATIONS AND SUGGESTIONS CHARACTERISTICS INSTALLATION & USE MAINTENANCE Product Specification & Technical Parameters Model AKR3200/IX 220-240V Rated Voltage Rated Power Frequency 50Hz Light Power 2x20W Motor Power 320W...
- Page 3 * Only a qualified and trained service technician can undertake the work of installation and servicing. * Check that the mains voltage corresponds to the one indicated on the rating plate fixed inside the hood. * Check that the domestic power supply guarantees adequate earthing.
- Page 4 on its correct usage. MAINTENANCE * Proper maintenance of the Range Hood will assure proper performance of the unit. * Disconnect the hood from the main supply before carrying out any maintenance work. * Clean and/or replace grease filters after specified period of time. * Clean the hood using a damp cloth and a neutral liquid detergent.
- Page 5 person responsible for their safety. Children should be supervised to ensure that they do not play with the appliance. * There shall be adequate ventilation of the room when the range hood is used at the same time as appliances burning gas or other fuels.
- Page 7 COMPONENTS Components 1pcs Grease filter 1pcs Hood body steel bolt Cross self-drill bolt Exhaust Exterior chimney Inner chimney Cross discal thread bolt Fixing frame Cross discal bolt-big head Flat rubber band Plastic distensible sleeve Documentations Instruction Manual Warranty Card INSTALLATION & USE Note 1: Carefully remove the protective film from chimney and front panel prior to final installation.
- Page 8 1. Drill the holes according to the distances indicated (Fig.2). 2. Fix the appliance to the wall and align it in horizontal position to the wall units. 3. When the appliance has been adjusted, fix the hood using the screws A. For the various installations use screws and screw anchors suited to the type of wall (e.g.
- Page 9 Fig.4 Fig.5 DUCT FIXING Caution: To reduce the risk of fire, recommend use aluminium ductwork. φ 1. Attach an adequate length of 150mm round duct into the recessed area of the air outlet adapter. 2. The duct has to be secured using two screws from two sides of the air outlet adapter.
- Page 10 Caution: To reduce the risk of fire, use metal ductwork only. 1. Decide where the ductwork will run between the hood and the outside. 2. A straight, short duct run will allow the hood to perform most efficiently. 3. Long duct runs, elbows, and transitions will reduce the performance of the hood.
- Page 11 OPERATION OF CONTROLS A= Filtering system / Set clock B= Delay Timer C= Speed S1/ “-” adjust / off D= Digital display E= Speed S1/ “+” adjust / off F= Alarm G= Light When the Key A is flashing, at the same time “ ”is flashing on the digital display, it reminds the user to clean the filters.
- Page 12 4. Press ‘C’ / ‘E’ to change the speed of operation when timer stops blinking。 5. Press “F” to set the working time. Press it for 3 seconds, clock “ ”on the digital display will flash and then press key C or E to set the working time. 6.
- Page 13 Bulbs may be hot. Take care while replacing. Replace lamp Take off the cap by a screw driver. Remove the metal ring Replace the bulb with a 20 watt halogen light. We recommend only using lamps of the same specification as the one being replaced.
- Page 14 to remain in contact with aluminum finish for extended periods. Many of these compounds contain chemicals that may be harmful. Rinse with water after exposure and wipe dry with a clean cloth. * Painted surfaces should be cleaned with warm water and mild detergent only.