Whirlpool AKR 891 Important Safety Instructions Manual page 10

Selecting the hob surface
This operation optimises automatic operation of the hood.
Switch the hood OFF.
Press keys "2" and "3" at the same time for 5 seconds until the hob being used is displayed, according to the following legend:
LD1 LEDs on = gas hob
LEDs LD1+LD2 on = Induction hob
LEDs LD1+LD2+LD3 on = Electric hob
The type of hob can be selected pressing keys "2" and "3".
Ten seconds after the type of hob has been selected, this will be automatically saved by the system.
Saving of the selection will be confirmed by the selection itself flashing 3 times. Once the selection has been saved the hood will go off.
Note: The type of hob set by default is the Gas hob.
MAINTENANCE
WARNING:
- Disconnect the appliance from the power supply.
Cleaning the perimeter suction panel
Dismantling:
Pull the panel (FRONT SIDE) downwards
Cleaning:
The suction panel must be cleaned with the same frequency as the grease filter. Use a damp
cloth and a soft liquid detergent.
Do not use products containing abrasives. DO NOT USE ALCOHOL!
Assembly:
The panel must be fixed from the front, hinged to the appropriate pins on the surface of the
hood.
WARNING: Always check that the panel is fitted properly.
GB10