Dell 1000W User Manual page 43

Table 4. Status Summary Screens (continued)
Status Summary Screen
The notice and alarm screens are visible only when notices or alarms are active. There is a separate
screen for each active notice or alarm. If there are no active notices or alarms, a "No Active Alarms"
message appears in a single screen between the UPS status summary and the battery status screen. If
there are multiple notices or alarms, scroll through each notice or alarm screen to reach the first battery
status screen.
NOTE:
Events are not shown in status summary screens. They appear only in the Event Log.
Table 5 describes the available battery status screens. Only one battery status is available at a time.
Table 5. Battery Status Screens
Battery Status Screen
Battery charging
Battery floating
Battery resting
Battery discharging
Battery disconnected
Charger disabled
Description
Normal Mode
The UPS is operating in Normal mode from utility power. The UPS monitors and
charges the batteries as needed and provides filtered power protection to your
equipment.
Standby Mode
When the UPS is turned off and remains plugged into a power outlet, the UPS is
in Standby mode and utility power supplies the connected equipment. The UPS
is not supporting the load, but is ready to assume the load on command.
Description
Batteries are charged in constant current mode.
Batteries are charged in constant voltage mode.
Batteries are connected but are not being charged or discharged.
(This is part of the normal charging cycle.)
Batteries are discharging.
Batteries are unavailable because they are disconnected.
The battery charger is off. You can enable the Charger setting from the Settings
menu (see page 48).
43
|
Operation