Advertisement
71060 Rev5
17/5/06
12:52
DUST CANISTER
Emptying
To obtain the best results from your
cleaner empty the dust canister
regularly, otherwise the airflow and
cleaning power will be reduced.
1
Remove the dust canister from the
product by pressing the dust
canister release button ‹ Lift up the
lid and remove the canister from the
product, pulling the dust canister
away from the product. C
2
Everytime the dust canister is
emptied, turn the yellow dial (a
minimum of 5 revolutions) prior to
pressing the dust canister release
button (this will agitate the fine dust
between the filter pleats and restore
the air flow)
3
Holding the dust canister over a
dustbin press the dust release
button as shown D, the bottom of
the dust container will drop down to
release the dirt.
4
Close the bottom of the dust
canister by pressing the base
upwards until it clicks into place.
5
Refit the dust canister back into the
product. Make certain the dust
canister feet are located in place.
6
Close the lid securely.
ALLERGY
SUFFERERS
If the allergy sufferer is emptying the
product it is recommended that the
container is placed into a plastic bag
to empty.
1
Place the container inside the plastic
bag, releasing the container with one
hand whilst holding the top of the
bag closed with the other, leave the
dust to settle for a few seconds
before carefully removing the empty
canister. The plastic bag can then be
sealed and disposed of.
6
UK Helpline 0870 060 2604
Page 6
FILTERS
Cleaning canister
filter
1
To access filter assembly rotate the
canister lid anti-clockwise and lift off
lid E.
2
Use the filter cleaning brush to
remove any fluff from the outside of
the mesh filter or gently tap.
3
Rotate mesh filter anti-clockwise to
disassemble.
4
Shake the pleated filter to remove an
dust.
5
Both the mesh and pleated filters
may be washed (in cool water only)
but must be thoroughly air dried
before refitting.
Locate in the canister and replace
the lid, twisting to lock into place.
IMPORTANT: Do not use detergents
to clean the filter. The filter should be
regularly washed, and must be
thoroughly dry before the machine is
used.
•
A spare filter is provided.
•
The dust container may not lock
back onto the machine unless the
filter is fitted correctly
Vacuum freshener
(certain models only)
1
After emptying the dust canister and
removing the filters (as described in
points 1-4 above) open the clear
packaging and remove the vacuum
freshener.
2
Place it directly into the dust canister
as shown.F
3
Refit the filters and canister (as
described in point 5 above).
Only place the vacuum freshener
directly into the dust canister. Do not
place in the filter or any other part of
your vacuum cleaner.
New vacuum freshener these can be
purchased from Morphy Richards on
Replacement parts line.
Replacement Parts 0870 167 6635
C
D
E
F
Ireland Helpline 1800 409119
6
Advertisement
