Advertisement
Quick Links
Advertisement
Subscribe to Our Youtube Channel
Related Manuals for Lakes Classic LKSS Series
Summary of Contents for Lakes Classic LKSS Series
- Page 1 SHOWER SCREEN (8mm) Installation / Maintenance Instructions Rev 02.12 Rev 04.09...
-
Page 2: Important Notes
Before any work is carried out the root cause of the problem must be identified. Lakes Bathrooms service engineers are available if necessary to consult / carry out remedial work. Call Lakes Bathrooms HELPLINE. -
Page 3: Supplied Parts
SUPPLIED PARTS : Cover Section (Wall Profile) Wall Profile (1900mm 1x) (1900mm 1x) fig G fig A Bottom Seal (Main Panel) (1x) fig B Bracing Arm dia 22 x 940 long (1x) fig E Panel Sub Assy (1x) fig B Post Top Wall Bracket Kit Bracket (1x) - Page 4 (Allen Key) Hacksaw Lakes Shower Screen is fully reversible, so is suitable for fitting Left or Right handed (LH construction is detailed ~ Reverse for RH construction). Ensure Tray is correctly levelled & that tray / wall (tile) joints are sealed &...
- Page 5 Main Panel Construction : Top Plug Push in to Rail Post Top : Affix to post with (2x) 4x25 C/Sunk screws. NOTE : Bottom Seal & base pad Post Base : may be omitted in favour of Apply clear silicone to glass silicone sealant bead if slot &...
- Page 6 With door post vertical, measure distance between back wall & inside of post (B). Mark & cut bar B + 13mm (1/2”) Measure distance from side wall to inside of post (C). Measure, mark & drill dia 8mm, fit wall plug & threaded wall plate...
- Page 7 1. Fit bracing bar into finial 2. Slide sleeve (wall bracket) onto bar, Fit Finial onto Post Top using position bar inline with wall plate & M6 x 35 C/Sunk screw. 3. Screw sleeve upto wall, then undo until Lightly tighten screw only at this stage grubscrews are at top position.
- Page 8 Note : If NOT using supplied bottom seal, ensure silicone sealant is applied over ‘dotted’ length also ! Use of good quality silicone sealant & cleaning / degreasing of all joint areas is recommended. Apply continuous silicone sealant bead as indicated EXTERNALLY ONLY...
-
Page 9: Basic Troubleshooting
In the unlikely event of an enclosure leak, water will be visible on the outside of the enclosure itself, or around the perimeter silicone seal ONLY. Water / moisture appearing outside this area (ie at floor level) is normally due to incorrect tray installation. Lakes Bathrooms Ltd Lakes Bathrooms Ltd Service : Northern Ireland...
Need help?
Do you have a question about the Classic LKSS Series and is the answer not in the manual?
Questions and answers