Advertisement
Quick Links
Advertisement
Related Manuals for Lakes HORIZON Walk In Series
Summary of Contents for Lakes HORIZON Walk In Series
- Page 1 HORIZON - Walk In Shower Panel Installation / Maintenance Instructions Rev 02.22...
-
Page 2: Important Notes
However should maintenance be required it should be carried out by a competent person with reference to these instructions. Before any work is carried out the root cause of the problem must be identified. Lakes Bathrooms service engineers are available if necessary to consult / carry out remedial work. Call Lakes Bathrooms HELPLINE. - Page 3 Supplied Parts : Panel Sub Assy Wall Profile le Extension Profile 1x (with Foam Seal) 1x (2m long) (2m long) optional fit Cover Profile (screws) 1x Bottom Trim 1x Wall / Ext Profile Caps 2x Vert frame Caps handed pair Bottom Trim End Cap 1x General Fixings...
- Page 4 Tools Required Spirit Level (with vertical ‘bubble’) Pencil Tape Measure Power drill & 8mm masonry bit Hacksaw Good quality silicone 2,5mm Hexagon 3mm HSS sealant & applicator (Allen) Key drill bit Pozidriv Screwdriver Horizon Walk In enclosures are fully reversible. Versatile construction permits their use onto a wide range of base footprints, tray or wetroom installations.
- Page 5 Select Hand ~ Fit bottom trims Select ‘hand’ for unit build. Trim is fitted at base only. Apply a continuous bead of silicone along inside of trim then carefully push trims fully onto bottom edge of glass panel. Butt trim up to vertical profile. Do not bend or strike with hard objects, a soft mallet or hammer &...
- Page 6 1. With glass in position & plumb in all directions, measure distance from back wall to glass (as shown) : Dim X 2. Remove wall bracket & glass clamp from bar. 3. From slotted end of bar ONLY, mark & cut bar to X minus 11mm.
- Page 7 Top Caps : Working from top or bottom, press in cover section. Fit cover caps to tops of profiles. Corner Piece : Fit corner piece to bottom corner of ‘open’ glass edge. Use Clear silicone to retain ~ wipe off excess.
- Page 8 SEALING : Use of good quality silicone sealant & cleaning / degreasing of all joint areas is recommended. Apply continuous silicone sealant bead EXTERNALLY ONLY to all panels in contact with tray rim / floor & vertically approx 50mm (2”) between wall & wall profile.
-
Page 9: Basic Troubleshooting
The foam seal provided on the wall profile will tolerate most grouted joints. If excessively deep joints are present, & leakage does occur, additional silicone sealant may be applied over full length of wall profile / wall joints. Lakes Bathrooms Ltd Service : Northern Ireland Alexandra Way...
Need help?
Do you have a question about the HORIZON Walk In Series and is the answer not in the manual?
Questions and answers