Page 2
Important Notes : Please Read Carefully & retain these instructions for Future Reference. For ease & safety we advise that two persons assemble this product. Protect bath surfaces at all times. Check for cables, pipes etc before drilling walls. Ensure all surfaces are dry, clean & free of loose debris / dust. Unpack goods with care (small parts can become lodged in packaging &...
Page 4
Handing Overview (If required) Unit is supplied handed (left or right hand). If reversal is required, place unit on a protective surface front face down. Unscrew and remove door glass hinge clamps (see exploded view fig A). Remove and flip door glass horizontally as shown, rebuild hinge clamps, fully tighten screws, fit screw cover caps.
Installation (Left Hand Unit Shown) Bath screen is supplied handed, so may be fitted to left or right hand wall, on suitable bathtub. (See page 3 if handing change required) Ensure bath rim is level & that bath / wall (tile) joints are sealed & cured over entire length of bath sides (See Note) prior to fitting screen.
Page 6
Step 1. Before fitting the bathscreen, attach the panel levelling gasket underneath the end of the fixed panel. Step 2. Fit glass support under outer end of glass. Carefully lift screen into position, push fully into wall profile & down onto bath rim. Check & adjust screen for plumb and ensure parallel to bath edge. Step 3.
Page 7
Bracing Bar Installation Step 1. Offer bracing bar onto fixed glass. Decide preferred position/angle (45° optimal). Holding securely, mark wall hole positions. Remove bracing bar, drill and plug walls. Step 2. Remove Sleeve and pivot screw. Separate bar from glass bracket. Step 3.
/ bottom hinge ONLY. Water / moisture appearing outside this area (ie under the bathtub or at floor level) is normally due to incorrect bathtub installation / sealing. Lakes Bathrooms Ltd Service : Northern Ireland...
Need help?
Do you have a question about the SS100 and is the answer not in the manual?
Questions and answers