Innotek ADV-300 Manual

Bark Collar is branded under Innotek, MultiVet, Guardian, and Premier
Works based on Sound and Vibration
Attaching strap to spray device:
Filling the spray device:
Note: Never fill the device while your dog is wearing it, this may damage the fill-up valve.
If spray leaks out while filling device; increase downward pressure on the spray can to get a better
seal. You cannot overfill the device.
Inserting the battery:
Testing the spray device.
Multi-Brand Spray Bark Control
Remove keeper and buckle end from strap  slide strap under
metal loops and over top of device  slide keeper and buckle
back on strap (curve of keeper and buckle should face inside)
*Strap should not cover microphone.
Make sure device is turned off
Set on flat surface, fill-up valve turned up  Shake spray can
 Hold spray can upside down & insert aerosol tip into fill-up
valve  Press down firmly for 10 seconds  Release pressure
 Press down for another 10 seconds
Slide battery cover towards fill-up valve to remove battery lid
Insert 6 volt alkaline battery, positive
toward spray valve  Slide battery cover back on
Turn on/off switch on  blow or bark into the microphone 
collar should emit a burst of spray.
Replace as complete Kit:
Guardian GBC11-12131
Innotek, MultiVet KIT11122 or KIT11123
Premier: Spray Sense or GentleSpray
1 | P a g e