Download Print this page
Innotek SD-2000 Operation Manual

Innotek SD-2000 Operation Manual

Basic in-ground pet fencing system
Hide thumbs Also See for SD-2000:

Advertisement

Quick Links

B a s i c
In-ground Pet Fencing
S y s t e m
S D - 2 0 0 0
Operation Guide
Thank you for purchasing this Containment
System.
This electronic dog training system is among the
safest, most humane and effective training prod-
ucts you can buy. Used properly, the collar's elec-
tronic stimulation serves as a distraction that your
dog will find undesirable. By complying, your dog
quickly learns to shut off the stimulation, thus
gaining confidence in response to your com-
mands.
Please take a few minutes to read the instruction
manual prior to first use and retain the manual for
future reference. This instruction manual contains
important programming and set-up information to
help your training proceed as successfully as pos-
sible. For best results follow these important safe-
guards:
I M P O R TANT SAFEGUARDS
1.Obey all warnings contained in this manual.
2. The electronic dog collar is intended only for
use on dogs over 6 months of age. Never attempt
to use this product for any purpose not specifical-
ly described in this manual.
3.If you have any reason to believe that your dog
may pose a danger to others, harm itself, or would
react adversely after receiving stimulations from
this containment system, you should not rely
solely on this product to contain your dog.
4. Do not leave the collar on your dog for more
than 12 hours per day.
5.Never perform set-up procedures when the col -
lar is on your dog.
6. Monitor the system prior to use and after
changing any settings to ensure that the unit is
operating properly.
7.Do not use this system if you suspect the bat-
tery in the collar receiver is low.
8. Keep out of the reach of children.
9. Your dog will not respond to your system
unless:
A. You train your dog and utilize the Training
tips section of this manual.
B. The collar receiver has a working battery.
Do not use if you suspect a low battery in it.
C. The collar receiver is worn properly by the
dog.
D. The collar receiver is adjusted so that the
probes are touching your dog's skin.
E.The wall transmitter is on, connected to the
containment loop wire, and producing a
signal along the loop wire.
F. The 12-volt, 200 mAmp, adapter is
plugged into the wall transmitter and is
connected to a 110-volt household outlet.
10. The following precautions should always be
taken:
A.Never service or install a system or any
equipment during a thunder or electrical
storm.
B. Never install the wall transmitter where it
could be exposed to the elements. Doing so
will void the manufacturer's warranty.
C. Monitor the wall transmitter periodically to
ensure that the unit is operating properly and
is producing a signal along the loop wire.
D. Always remove your dog's collar receiver
before making any adjustments to your
system.
E.Allow your dog to get used to the collar
before you begin training. You want your dog
to accept the collar as part of a routine, not
to associate the collar with the stimulation.
11. To prevent the elimination of an adequate saf e
zone in your yard, any adjustments to the field
width must be tested prior to using the system
with your dog. Once the field width has been set
and tested, turning the knob in a clockwise direc-
tion will increase the stimulation area and may
eliminate the safe zone, thus causing stimulations
to be present throughout your entire yard. If you
have questions, please contact Innotek
826-5527, before using the system with your dog.
12. Realize that because individual dogs have
unique temperaments, there is no way of knowing
how your dog will react to its introduction to the
system. For the safety of your dog, initial training
should take place using a long leash to keep you
in control of the situation. Also realize that an
aggressive dog could turn against the handler
upon receiving the stimulation. Therefore, if you
feel your dog has an aggressive temperament
and/or it has a history of aggressive behavior, you
should consult a certified animal behav i o ri s t
before using this product.
1
®
at 1-800-

Advertisement

loading
Need help?

Need help?

Do you have a question about the SD-2000 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Innotek SD-2000

  • Page 1 If you solely on this product to contain your dog. have questions, please contact Innotek ® at 1-800- 4. Do not leave the collar on your dog for more 826-5527, before using the system with your dog.
  • Page 2 The wall transmitter generates an electronic sig- uct. If you have any questions or concerns after nal that is transmitted onto the boundary wire and reading this information, contact Innotek at 1-800- is received by the collar receiver when your dog 826-5527.
  • Page 3: Section 6. Troubleshooting

    If this situation or a your home. However, a close lightning strike may wire break should occur, refer to Containment damage the unit. Therefore, Innotek recom- Operation, Section 6.A. Troubleshooting. mends that you unplug the transmitter and dis- connect the wires during storms.
  • Page 4 Here are some always be set for 8.192 KHz. Do not move this key points to remember: jumper unless instructed to do so by an Innotek representative. • Consider all the obstacles - gardens, play areas, driveways, sidewalks, pools, porches, and water H.
  • Page 5 • To avoid future wire breaks caused by landscap- ing efforts, the lawn should never be aerated in the vicinity of the containment wire . • For your dog's safety, it is recommended to keep the containment wire at least ten feet from the street.
  • Page 6 opposite side of the house. When at a distance Once you are satisfied with the layout of your con- from the corner of the house equal to the con- tainment system, it is time to choose a proper tainment field width less one foot, do a hairpin location for the wall transmitter.
  • Page 7 1/2-inch deep cut across the driveway wire. For yards requiring more wire, boundary using a circular saw and masonry blade. Place kits are available from Innotek (1-800-826- the wire in the crack and seal with asphalt 5527). It is important that the same gauge wire sealant.
  • Page 8 If additional splices are required, they • Do NOT bury one section of wire within 10 feet may be purchased from Innotek. Using non- of another section or the signal may cancel. waterproof electrical tape, solder, or twisted wire •...
  • Page 9 placing wire into the holes. The other single boundary wire is placed into one of the other holes. T h a t leaves one extra hole that is not used.A pair of pliers should be used to press down on the top black part of the splice.
  • Page 10 minimized by orienting the boundary wire so If the field adjustment knob position is altered, that it is perpendicular to the buried wire for you must test the containment field for the approximately ten feet on each side of the desired setting and reposition the flags as buried wire (see graphic below).
  • Page 11 6. To prevent accidental stimulation inside the F. Place the training flags at the perimeter home, remove the collar from your dog's neck where the warning tone is heard. This will add when it comes inside. a visual cue to the audio warning tone and help your dog learn the boundar y.
  • Page 12 B.The Schedule D. Training Lessons The six dog-training lessons take place over the Lesson 1: The Retreat Pattern course of about 4 weeks. For total success it is Before you start to train, make sure the collar necessary to complete the entire course. receiver is functioning and the battery has ade- Practice sessions are 10-15 minutes each, 2 quate power.
  • Page 13: Lesson 6: Removing The Flags

    If, for any reason, your system still does not operate as described in this manual or if you have any questions or problems not includ- ed in this manual, please call Innotek at 1-800-826-5527.
  • Page 14 Page 10 D. Dog’s hair is too long or thick. Trim the hair or order special thick-haired probes from Innotek. Page 10 E.Receiver battery needs to be replaced. Page 3 F. Verify the wall transmitter is on and functioning properly.
  • Page 15 Dog Response Problem Possible Solutions Reference 6.Dog receives stimulation inside C. Reposition the boundary wire farther the home. (continued) from the house. Page 9 D. Place wall transmitter away from areas where the dog may be confined.A low level containment signal is radiated from these components and can cause the collar receiver to deliver stimulation.
  • Page 16 If the indicator light is still off, the malfunction is in the transmitter or the AC adapter. Contact 9. Back away from the wire and approach it Innotek at 1-800-826-5527 for assistance. again. Determine the distance between you and the wire when the collar activates. The distance C.Wire Break Location Test Procedure...
  • Page 17: Section 7. General Maintenance Tips

    LIMITED LIFETIME WARRANTY 13. After completing the entire boundar y, return to the mar ked spots. Examine the wire for 3 to Innotek warrants that this product will be 4 feet in each direction. free from defects in material and work- manship, under normal use, for a period 14.
  • Page 18 Innotek and Innotek logo are registered trademarks of Innotek, Inc. All other product or service names are the property of their respective owners. © 2002, Innotek, Inc.All rights reserved.
  • Page 19 Warning 1: Occasionally a dog cannot be trained to respond to a remote trainer or containment system. Sometimes even a properly trained dog may disobey a command. Therefore, Innotek, its distributors, and dealers cannot guarantee that the system will, in all cases, keep the customer’s dog from disobeying commands.
  • Page 20 2100222-1...