Watts ENWARE SP204DIV Installation And Maintenance Instructions

Wall mounted fixed bath spout with diverter

Download this manual

Wall Mounted Fixed Bath Spout with Diverter

Installation and Maintenance Instructions

SP204DIV

technical data

Working Pressure Range

Maximum Working

Temperature

Inlet Connection

Enware products are to be installed in accordance with the Plumbing Code of Australia (PCA) and AS/NZS3500.

Installations not complying with PCA and AS/NZS 3500 may void the product and performance warranty provisions.

Reference should also be made to the Australasian Health Facility Guidelines (AHFG), ABCB and Local Government

regulations when considering the choice of, and the installation of these products.

This product must be installed and commissioned by a qualified plumber.

For use with potable water only.

NOTE: Enware Australia advises:

1. Due to ongoing Research and Development, specifications may change without notice.

2. Component specifications may change on some export models.

I00576_12 Feb 2024

1300 369 273 | info@enware.com.au | enware.com.au

Min 50 kPa

Max 500 kPa

70°C

1/2" BSP (15mm) Female

Need help?

Do you have a question about the ENWARE SP204DIV and is the answer not in the manual?

Page 1 Wall Mounted Fixed Bath Spout with Diverter Installation and Maintenance Instructions SP204DIV technical data Working Pressure Range Min 50 kPa Max 500 kPa Maximum Working 70°C Temperature Inlet Connection 1/2” BSP (15mm) Female Enware products are to be installed in accordance with the Plumbing Code of Australia (PCA) and AS/NZS3500. Installations not complying with PCA and AS/NZS 3500 may void the product and performance warranty provisions.
Page 2 installation • Ensure all supply lines are flushed thoroughly to remove debris prior to the installation of this product. Strainers (40 mesh) are recommended if debris is an ongoing problem. • A pressure reduction valve may be required to comply with 1/2”...
Page 3 maintenance CLEANING Enware products should be cleaned with a soft damp cloth using only mild liquid detergent or soap and water. Do not use cleaning agents containing a corrosive acid, scouring agent or solvent chemicals. Do not use cream cleaners, as they are abrasive. Use of unsuitable cleaning agents may damage the surface.
Page 4 - WATTS AUSTRALIA EFFECTIVE FROM 20 November 2023 3. Our responsibilities This Warranty Statement applies to products supplied by Australian Valve (a) In the event that the Supplier is reasonably satisfied that there is a Group Pty Ltd (ACN 068 227 270) (AVG) or Enware Pty Ltd (ACN 662...