Electrical Requirements - Morphy Richards BLENDER - MANUAL 3 Manual

Do not overfill the blender. This could
•
cause damage to the motor. The 3A
fuse will blow if the blender is over
loaded. Replace fuse and do not
exceed the maximum recommended
volumes. Refer to the operating chart.
Do not blend for longer than the time
•
periods recommended in the operating
chart.
When using the blender ensure
•
the lid is in place before switching on
and do not remove the lid until the
blade has stopped rotating.

Electrical requirements

Electrical requirements
Electrical requirements Electrical requirements Electrical requirements
Check that the voltage on the rating plate of
your appliance corresponds with your house
electricity supply which must be A.C.(Alternating
current).
If the socket outlets in your home are not
suitable for the plug supplied with this appliance
the plug should be removed and the appropriate
one fitted.
IMP0RTANT : THE PLUG REMOVED FROM
THE MAINS LEAD, IF SEVERED, MUST BE
DESTROYED AS A PLUG WITH A BARED
FLEXIBLE CORD IS HAZARDOUS IF EN-
GAGED INTO A LIVE SOCKET OUTLET.
Should the fuse in the 13 amp plug require
replacement, a 3 amp BS1362 fuse must be
fitted.
WARNING : THIS APPLIANCE MUST BE
EARTHED.
Blender use Blender use
Blender use Blender use Blender use
Use your blender for soups, sauces, drinks,
pates, mayonnaise, dressings etc.
BLENDER
Features of your blender Features of your blender
Features of your blender Features of your blender Features of your blender
3
3
Filler cap
Lid
Jug
Blades
Seal and blade assembly
Jug base
Blender base unit
Control switch
13/8/02, 12:26 PM