Dell Precision NX046 User Manual page 246

12 Reinstall the drive panel (see "Replacing the Drive Panel" on page 237).
13 Ensure that all connectors are properly cabled and firmly seated.
14 Replace the computer cover (see "Replacing the Computer Cover" on
page 161).
NOTICE:
device and then plug it in to the computer.
15 Connect your computer and devices to their electrical outlets, and turn
them on.
See the documentation that came with the drive for instructions on
installing any software required for drive operation.
16 Enter the system setup program (see "System Setup" on page 89) and
select the appropriate Diskette Drive option.
17 Verify that your computer works correctly by running the Dell Diagnostics.
See "Dell Diagnostics" on page 136.
Removing a Floppy Drive (Desktop Computer)
1 Follow the procedures in "Before You Begin" on page 151.
2 Remove the computer cover (see "Removing the Computer Cover" on
page 153).
3 Remove the drive panel (see "Removing the Drive Panel" on page 233).
4 Disconnect the power and data cables from the back of the floppy drive.
5 Disconnect the other end of the drive cable from the system board
connector labeled "DSKT." To locate system board connectors, see "System
Board Components" on page 28.
246
Adding and Replacing Parts
To connect a network cable, first plug the cable in to the network port or