Table of Contents
Advertisement
Quick Links
INSTALLATION INSTRUCTIONS
INSTALLATION AND SERVICE MUST BE PERFORMED BY A QUALIFIED
IMPORTANT: SAVE FOR LOCAL ELECTRICAL INSPECTOR'S USE.
READ AND SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE.
WARNING
FOR YOUR SAFETY: Do not store or use gasoline or other flammable vapors or
liquids near this or any other appliance.
Table of Contents
IMPORTANT SAFETY INSTRUCTIONS........ 2
Product Dimensions ........................................ 4
Cabinet clearances.......................................... 4
Location of the gas and electric outlets ........... 5
Installing the backguard .................................. 5
Installing the front/side skirting ........................ 5
Island installation............................................. 6
Electrical connection ....................................... 8
Gas safety ....................................................... 9
Gas connection ............................................. 10
Important Note to the Customer
Keep these instructions with your owner's guide for
future reference.
WARNING
If the instructions contained in this manual are not followed precisely, a fire
or explosion may result causing property damage, personal injury or loss of life.
FOR YOUR SAFETY:
• Do not store or use gasoline or other flammable vapors or liquids near this or any other appliance.
WHAT TO DO IF YOU SMELL GAS:
• Do not try to light any appliance.
• Do not touch electrical switches; do not use any phone in the building.
• Immediately call your gas supplier from a neighbor's phone. Follow the gas supplier's instructions.
• If you cannot reach your gas supplier, call the fire department.
INSTALLATION AND SERVICE MUST BE PERFORMED BY A QUALIFIED INSTALLER,
SERVICE COMPANY OR GAS SUPPLIER.
Note: For appliances installed in the State of Massachusetts, go to page 10.
Note: When operating at elevations higher than 2000 ft. above sea level, the appliance rating
should be reduced by 4 percent for each additional 1000 ft.
All rights reserved. Printed in Italy
30" DUAL FUEL RANGE
INSTALLER.
Conversion to Propane gas (LPG).................13
Wall and floor attachment ..............................17
Door removal .................................................19
Important Notes to the Installer
1. Read all instructions contained in these installa-
tion instructions before installing the range.
2. Remove all packing material from the oven and
the drawer compartments before connecting the
electrical and gas supplies to the range.
3. Observe all governing codes and ordinances. Be
sure to leave these instructions with the con-
sumer.
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Electrolux ECFD3068ASA
Summary of Contents for Electrolux ECFD3068ASA
-
Page 1: Table Of Contents
INSTALLATION INSTRUCTIONS 30” DUAL FUEL RANGE INSTALLATION AND SERVICE MUST BE PERFORMED BY A QUALIFIED INSTALLER. IMPORTANT: SAVE FOR LOCAL ELECTRICAL INSPECTOR'S USE. READ AND SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE. WARNING FOR YOUR SAFETY: Do not store or use gasoline or other flammable vapors or liquids near this or any other appliance. -
Page 2: Important Safety Instructions
30” DUAL FUEL RANGE INSTALLATION INSTRUCTIONS IMPORTANT SAFETY INSTRUCTIONS This manual contains important safety symbols and insulating pad or sheet of ¼" (10,16cm) thick ply- instructions. Please pay attention to these symbols wood between the range and carpeting. and follow all instructions given. •... -
Page 3: Safety Codes And Standards
30” DUAL FUEL RANGE INSTALLATION INSTRUCTIONS • In the event of an electrical power outage, the sur- Tip Over Hazard face burners can be lit manually. To light a surface WARNING burner, hold a lit match to the burner head and slowly turn the Surface Control knob to LITE. -
Page 4: Product Dimensions
30” DUAL FUEL RANGE INSTALLATION INSTRUCTIONS Product Dimensions Cabinet clearances min. 762 mm min. 30” 760 mm 29” 15/16” 628 mm 24” 5/8 min: 654 mm min: 25 3/4" min. 508 mm min. 20” max: 658 mm max: 25 14/16” min. -
Page 5: Location Of The Gas And Electric Outlets
30” DUAL FUEL RANGE INSTALLATION INSTRUCTIONS Installing the backguard The side cabinet depth (clearance F) must match the front edge of the range side panel: The backguard provided is an integral part of the appliance; it must always be positioned and secured correctly on the cooktop. -
Page 6: Island Installation
30” DUAL FUEL RANGE INSTALLATION INSTRUCTIONS 3. Fasten the front skirting to the appliance using 7. Fasten the side skirting to the appliance using the the screws that were previously removed. screw that was previously removed. 8. Repeat the procedure for the other side skirting section. -
Page 7: Unpacking, Moving And Positioning The Range
30” DUAL FUEL RANGE INSTALLATION INSTRUCTIONS The side cabinet depth (clearance A) must match • Before moving range ensure legs are installed the front edge of the range side panel: completely. • The floor under the legs should be protected (wood, strips, carpet, paneling, etc.) before push- ing the unit into position. -
Page 8: Electrical Connection
30” DUAL FUEL RANGE INSTALLATION INSTRUCTIONS Electrical connection The appliance must sit level on the floor to ensure stability • Screw or unscrew the bottom part of the foot until Electrical shock hazard WARNING the appliance is stable and level on the floor. The adjustment range of the screw is 1.37 inches (35 •... -
Page 9: Gas Safety
30” DUAL FUEL RANGE INSTALLATION INSTRUCTIONS See the rating plate for technical specifications. The rating plate is visibly located on the right side of the Electrical shock hazard WARNING oven door frame. This ID plate must never be removed. • For personal safety, this appliance must be properly grounded. -
Page 10: Propane Gas Installation
30” DUAL FUEL RANGE INSTALLATION INSTRUCTIONS IMPORTANT SAFETY NOTICE: Burning gas cook- To convert the appliance to propane gas see ing fuel generates some by-products which are on "Conversion to Propane gas (LPG)". The conversion the list of substances which are known by the State must be done by a qualified technician or installer. - Page 11 30” DUAL FUEL RANGE INSTALLATION INSTRUCTIONS Location of the appliance’s Gas and The technical data tables for the nozzles and burn- ers are shown below: Electric connections 1 - Circular Dual Flame burners. 2 - Circular Single 4 Gas connection Flame burners.
-
Page 12: Testing For Gas Leaks
30” DUAL FUEL RANGE INSTALLATION INSTRUCTIONS Adjusting the minimum gas setting Important Notes for Gas Connection: • The appliance and its individual gas shutoff valve Circular Dual Flame burners must be disconnected from the gas supply piping NOTE: The Circular Dual flame burners are fitted system during pressure testing of the system at with two minimum adjustment screws. -
Page 13: Conversion To Propane Gas (Lpg)
30” DUAL FUEL RANGE INSTALLATION INSTRUCTIONS When converting for propane gas use, the pressure Circular Single Flame burners and Fish burner supplied to the regulator must be between 11" and NOTE: The Circular Single Flame burners and 13" of the water column. The pressure regulator Fish burners are fitted with one minimum adjust- located in the inlet of the range manifold must ment screw. - Page 14 30” DUAL FUEL RANGE INSTALLATION INSTRUCTIONS 3. Invert the plastic regulator stem to achieve the 4. Remove the internal (8) and external (9) nozzles configuration “B” for Propane Gas and screw it in and replace them with the LPG nozzles (see tightly.
- Page 15 30” DUAL FUEL RANGE INSTALLATION INSTRUCTIONS Correct burners placement Replacing the Fish burner nozzles 1. Remove the cooktop grates. Pay attention to place the burners in their correct 2. Remove the burner covers (1), the flame- zones prior to remounting them spreader crowns (2) from the burner base (3).
- Page 16 30” DUAL FUEL RANGE INSTALLATION INSTRUCTIONS The flame-spreader crown must be centered on the Fish burner: burner skirt. Take care to align the flame-spreader crown recesses (A) to the igniters (B). The burner cover must be leveled and centered with respect to the burner skirt.
-
Page 17: Wall And Floor Attachment
30” DUAL FUEL RANGE INSTALLATION INSTRUCTIONS Wall and floor attachment Positioning the bracket using the template: 1. Choose the correct side of the template, based on the model. Electrical shock hazard WARNING • Use extreme caution when drilling holes in the wall or floor. - Page 18 30” DUAL FUEL RANGE INSTALLATION INSTRUCTIONS Installing the anti-tip bracket: 5. Use the specified distance from the side of the appliance to the bracket holes. 1. Ensure that the electrical connection is in the cor- rect position. 2. Assemble the bracket. 6.
-
Page 19: Door Removal
30” DUAL FUEL RANGE INSTALLATION INSTRUCTIONS 7. Use the following distances for the distance from 9. Push the cooker towards the wall, and at the the side of the appliance to the bracket holes. same time, insert the bracket in the plate that is fastened to the rear of the appliance. - Page 20 914780094-C-032021...
Need help?
Do you have a question about the ECFD3068ASA and is the answer not in the manual?
Questions and answers