BMW R 1200 GS Rider's Manual page 123

care not to damage the RDC
sensor. Be sure to draw the
attention of the authorised BMW
Motorrad dealer or specialist
workshop to the fact that the
wheel is fitted with an RDC
sensor.
Remove the front wheel
Make sure the ground is level
and firm and place the motor-
cycle on its centre stand.
with BMW Motorrad Integral
OE
ABS II
Unclip two retaining clips 1
holding the sensor cable to the
brake line.
Mask off the parts of the wheel
rim that could be scratched in
the process of removing the
brake calipers.
Once the calipers have
been removed, there is
a risk of the brake pads being
pressed together to the extent
that they cannot be slipped back
over the brake disc on reas-
sembly.
Do not operate the handbrake
lever when the brake calipers
have been removed.
Remove securing screws 2 of
the left and right brake calipers.
Force the brake pads 3 slightly
apart by rocking brake cal-
liper 4 back and forth against
brake disc 5.
Carefully pull the brake calipers
back and out until clear of the
brake discs.
8
119
z