Pairing - BMW MOTORRAD AUDIO SYSTEM Rider's Manual

Pairing

6
Two Bluetooth devices have to
recognise each other before they
42
can communicate. This process
of mutual recognition is known
as pairing. When two devices
have paired they remember each
other, so the pairing process is
conducted only once, on initial
contact.
Two BMW communication sys-
z tems with Bluetooth standard 2.0
are required if both rider's helmet
and passenger's helmet are to
be paired to the audio system. If
either of the two BMW systems
is using Bluetooth standard 1.2,
only one helmet can be paired.
Refer to the operating instruc-
tions of your communication sys-
tem for information on Bluetooth
standards.
During the pairing process, the
audio system searches for other
Bluetooth-compatible devices
within its reception range. The
conditions that have to be satis-
fied before the audio system can
recognise another device are as
follows:
The device's Bluetooth func-
tion must be active
The device must be "visible" to
others
The device must support the
A2DP profile
Other Bluetooth-compatible
devices must be OFF (if, for
example, you are going to run
the pairing procedure for two
communication systems, make
sure that the audio system is
OFF)
Please consult the operating in-
structions for your communica-
tion system.
Only one music playback device
can be saved in the BMW Motor-
rad communication systems. It is
not possible to pair with the au-
dio system if some other device
has already been saved.
Once the audio system and the
BMW Motorrad communication
system have been paired, other
music devices have to be con-
nected by means of the con-
nector in the stowage compart-
ment.

Pairing

Switch on Bluetooth function.
Switch off all other Bluetooth
enabled devices (e. g. mobile
telephones) within ten metres
(or at least their Bluetooth
function).
Activate helmet's Bluetooth
function and visibility (see hel-
met operating instructions).