EGO POWER+ ST1520S Operator's Manual page 3
56-volt lithium-ion cordless 15" string trimmer
Hide thumbs
Also See for POWER+ ST1520S:
- Operator's manual (108 pages) ,
- Operator's manual (108 pages) ,
- User manual
Advertisement
Available languages
Available languages
READ ALL INSTRUCTIONS!
READ & UNDERSTAND
OPERATOR'S MANUAL
WARNING:
and other construction activities contains chemicals known to the state of California
to cause cancer, birth defects or other reproductive harm. Some examples of these
chemicals are:
◾
Lead from lead-based paints
◾
Crystalline silica from bricks and cement and other masonry products, and
◾
Arsenic and chromium from chemically-treated lumber.
Your risk from these exposures varies, depending on how often you do this type of
work. To reduce your exposure to these chemicals: work in a well ventilated area, and
work with approved safety equipment, such as those dust masks that are specially
designed to filter out microscopic particles.
56-VOLT LITHIUM-ION CORDLESS 15" STRING TRIMMER—ST1520 & ST1520S
Some dust created by power sanding, sawing, grinding, drilling
3
Advertisement
Need help?
Do you have a question about the POWER+ ST1520S and is the answer not in the manual?
Questions and answers
How do I load the string
To load the string on the EGO POWER+ ST1520S string trimmer:
1. Remove the battery pack from the trimmer.
2. Cut a 13 ft. (4 m) length of recommended nylon cutting line (maximum 0.095 in./2.4 mm diameter).
3. Insert the line into one eyelet and push it through until it comes out the opposite eyelet.
4. If the line does not go through, mount the battery and briefly press the line-loading button to release the lower cover, then try again.
5. Remove the battery if it was mounted.
6. Pull the line from both sides until equal lengths are on each side.
7. Reinstall the battery pack.
8. Press and hold the line-loading button to start winding the line into the trimmer head.
9. Release the button when about 7 inches (17.8 cm) of line remain on each side.
Avoid repeated button presses in rapid succession to prevent motor damage.
This answer is automatically generated
I broke the carbon fiber shaft, is it possible to get a replacement and is it possible to replace it?