Page 1
Technical Support and E-Warranty Certificate www.vevor.com/support Dog-door-for-sliding-door USER MANUAL We continue to be committed to provide you tools with competitive price. "Save Half", "Half Price" or any other similar expressions used by us only represents an estimate of savings you might benefit from buying certain tools with us compared to the major top brands and does not necessarily mean to cover all categories of tools offered by us.
Page 2
Technical Support and E-Warranty Certificate www.vevor.com/support This is the original instruction, please read all manual instructions carefully before operating. VEVOR reserves a clear interpretation of our user manual. The appearance of the product shall be subject to the product you received. Please forgive us that we won't inform you again if there are any technology or software updates on our product.
VEVOR will not be held responsible for any unintended usage, and by purchasing this product, you accept full accountability for supervising the access it permits.
Kit includes Cutting Template Interior Frame Exterior Frame Closing Panel Screw (M4*75, M4*65 , M4*55 )and Screw Sleeves and Screw Caps: Both CWM01-S and CWM01-M have 5PCS Both CWM01-L and CWM01-XL have 7PCS Tools Needed Level Drill Tape Measure Cutting...
Page 5
Model and Parameters Suitable Door Thickness:1 1/16" ~ 2"(27~50mm ) CWM01-S: Flap Opening Size: 5 1/4"W × 8 1/8"H (133×206mm) Cutting Door Size: 6 1/2"W ×10 1/4 "H (165×260mm) CWM01-M: Flap Opening Size: 8 1/4"W × 12 1/4"H (210×311mm) Cutting Door Size: 9 1/2"W ×14 2/5"H (241×365mm)...
Prepare the door 3.If possible, remove the door from its hinges and place it on a raised level surface, such as two saw horses (3-1). The interior side of the door should face up. Make sure there is nothing underneath the door where you will cut the opening for the pet door.
Page 7
Cut the pet door opening NOTE: When drilling holes and cutting the opening for the pet door, wear safety glasses and make sure to hold the drill and jigsaw with both hands and at a 90- degree angle to the door 8.Drill 1/2-inch (12-millimetre) holes just inside the corners of the drawn template.
Install the pet door NOTE:If you purchased an Installation Adaptor, place the installation adaptor plates on the interior and exterior frames of the pet door before installation. The Installation Adaptor is necessary only if you are installing the pet door in a door less than 1 1/2 inches(38 millimetres) thick.
Page 9
It may help if you are on one side of the door and your pet is on the other. Do not force your pet through the pet door. 20. After your pet has gone through the pet door a few times, allow the flaps to touch your pet's back so he will become comfortable using the pet door on his own.
Misapplication of the product in contradiction to its intended function could lead to breaches of federal, state, or municipal regulations. 4. Liability Exclusion Vevor shall not be held accountable for any direct, indirect, punitive, incidental, special, or consequential harms, or any damages of any kind arising from or in connection with the proper or improper use of this Product.
Page 11
Product. 5. Amendments to Terms and Conditions Vevor Corporation retains the authority to amend the terms, conditions, and notices governing the provision of this Product at its discretion.
Page 12
Technical Support and E-Warranty Certificate www.vevor.com/support...
Need help?
Do you have a question about the CWM01-S and is the answer not in the manual?
Questions and answers