Advertisement
Technical Support and E-Warranty Certificate www.vevor.com/support
Flip Pet Door
USER MANUAL
We continue to be committed to provide you tools with competitive price.
"Save Half", "Half Price" or any other similar expressions used by us only represents an
estimate of savings you might benefit from buying certain tools with us compared to the major
top brands and does not necessarily mean to cover all categories of tools offered by us. You are
kindly reminded to verify carefully when you are placing an order with us if you are actually
saving half in comparison with the top major brands.
Advertisement
Table of Contents
Related Manuals for VEVOR CWM02-S
Summary of Contents for VEVOR CWM02-S
- Page 1 Technical Support and E-Warranty Certificate www.vevor.com/support Flip Pet Door USER MANUAL We continue to be committed to provide you tools with competitive price. "Save Half", "Half Price" or any other similar expressions used by us only represents an estimate of savings you might benefit from buying certain tools with us compared to the major top brands and does not necessarily mean to cover all categories of tools offered by us.
- Page 3 Technical Support and E-Warranty Certificate www.vevor.com/support This is the original instruction, please read all manual instructions carefully before operating. VEVOR reserves a clear interpretation of our user manual. The appearance of the product shall be subject to the product you received. Please forgive us that we won't inform you again if there are any technology or software updates on our product.
-
Page 4: Important Safety Information
VEVOR will not be held responsible for any unintended usage, and by purchasing this product, you accept full accountability for supervising the access it permits. -
Page 5: Tools Needed
Components Template M6 expansion tube Installation Guide Closing Panel M4*65mm Drywall Screws Washer M3.5*20 Drywall Screws Pet Door with Flaps Toggle Bolt Screw Caps Tools Needed Level Drill Tape Measure cutting Stud machine Finder Pencil ” (8mm) Framing Square Drill Bit scissor ”... - Page 6 Model and Parameters CWM02-S： Flap Opening Size: 5 1/4"W × 8 1/8"H (133×206mm) Cutting Wall Size: 7 1/4"W ×10 3/5"H(185×270mm ） CWM02-M： Flap Opening Size: 8 1/4"W × 12 1/4"H (210×311mm) Cutting Wall Size: 10 1/5"W ×14 3/4 "H(260×375mm） CWM02-L：...
- Page 7 Check for electrical and plumbing fixtures that could be in the wall where you wish to place the pet door. 3. Place the template against the wall. Align the lines on the Template with the lines on the wall. Tape in place. 4.Check that the template is square.The vertical lines of Both sides need to be extended up.
- Page 8 8.Fit Check: Using the A side of the pet door, check the fit. Do not force fit if it is tight. 9.If the hole is too small, simply remove the pet door and re-cut or file the hole slightly to enlarge. Do not cut morethan1/8"(3.2 mm) from your previous cut. Once the Pet door properly goes into the hole, adjust to ensure the Unit is square.
- Page 9 14.Remove the pet door from the inside wall. Drill out the marked holes with your 5/16”(8mm) drill bit. Be careful to keep these holes as straight as possible. 15.You are now ready to work from the outside wall.Line up the three holes on the template with the three holes that you just drilled.
- Page 10 Install and Attach Interior 19.Using the holes left by the drywall screws on the A side of pet door as pilot holes, drill a ½" (13 mm) hole for the toggle bolts. There must be a position 1.18" (30mm) on both sides. 20.Install the toggle bolts and screw caps into the A side of the pet Door as shown.
- Page 11 Useful Tip :You may need to start the toggle bolt into the hole. Be careful not to overtighten. Sometimes you need to hold the screw out so the toggle is locked while you tighten the screw until the toggle is tight enough that it will hold itself in place while you finish tightening.
-
Page 12: Replacement Flaps
Useful Tip : Sometimes it helps for you to be on one side of the door and your pet on the other. You may try persuading your pet through the door using a small piece of food or a treat. You May Need Use the Pet Door Installation and Weather Proofing Kit helps to insulate and weatherproof the pet door. -
Page 13: Terms Of Use And Limitation Of Liability
Misapplication of the product in contradiction to its intended function could lead to breaches of federal, state, or municipal regulations. 4. Liability Exclusion Vevor shall not be held accountable for any direct, indirect, punitive, incidental, special, or consequential harms, or any damages of any kind arising from or in connection with the proper or improper use of this Product. - Page 16 Technical Support and E-Warranty Certificate www.vevor.com/support...
Need help?
Do you have a question about the CWM02-S and is the answer not in the manual?
Questions and answers