PondMAX 02PS012 User Manual

SOLAR PUMP KIT USER'S MANUAL
1. OVERVIEW
1) The solar pump is designed for outdoor or indoor fountain use, and is
powered by a solar panel. In order to make the pump work by solar
energy, the solar panel needs to be placed in the sunlight with its solar
cells facing the sun as much as possible.
2) The performance of the pump depends on the sunlight intensity and
the incident angle at which sunlight strikes the panel surface.
3) The pump has a build-in function of dry-run protection The dry-run
protection function is supported by two sensor points on one side of the
pump housing (referring to the right photo). The pump works if both of
the points are submerged in water. If either or both points emerge out of water, the pump stops
working.
4) The pump flow rate can be adjusted by the flow valve (referring to the right photo).
5) The latest DC brushless motor technology is introduced in the pump design and manufacturing, so
that the pump has high efficiency and long service life.
2. COMPONENTS
1)solar panel with ground spike
3. ASSEMBLING
1) Unpack all components carefully.
2) For the application of pumping a water feature, screw the multilevel hose connector onto the pump outlet
and then connect the hose connector to the water inlet of the water feature with a suitable water hose.
3) For the application of creating a spraying up fountain, please follow the
steps below:
a) Mount the nozzle accessories on the top of the pump outlet. Totally,
there are three types of nozzle tip provided, including an apple
fountain tip, a volcano fountain tip and a special foam effective nozzle
tip which can trap a large amount of air into the water to significantly
boost the oxygen content in water.
b) Fix the pump at the floor of a water body, such as a small shallow pond
etc.
c) It is better to keep the pump off the pond floor to avoid sucking in the
pond waste into the pump, which would easily develop into pump
blockage.
d) To properly install the volcano fountain head, the extension tubes
should be used to lift the fountain head above the water surface, but as
low as possible so that the entire length of the water spray can be
exposed to maximize the visual effect, as shown in Fig 1.
e) To properly install the apple fountain head, the fountain head should be
lifted to a position above the water surface far enough to allow forming
an ideal apple shaped fountain. To adjust the size of the apple fountain
sphere, vary the water discharge gap by pressing or lifting the nozzle
top piece, as shown in Fig 2. The larger the discharge gap, the smaller
the apple sphere.
f) To properly install the foam effective fountain head, please make sure
the nozzle top piece is left out of water so that air can be sucked in
from the gap underneath it, as shown in Fig 3.
g) If all the 4pcs of extension tubes are used and the fountain head still
can not reach the right position, please uplift the pump body somehow.
Design for fountain
Item No.: 02PS012
2)solar pump 3)nozzle accessories 4)Multilevel hose connector
Fig 1
Fig 2
Fig 3