Sharp 14B-SC Operation Manual page 7

Operation of Controls
@ Power source and TV system
This TV set can be operated on AC200V—
240V, 50/60Hz. It is designed exclusively for
SECAM/PAL B/G ,D/K broadcast system
and NTSC-3.58/4.43MHz video playback.
@ Red/green/orange power and On-
Timer indicator
When the main power on/off button (O}) at
the front of the set is pressed, the TV set will
be in standby with the LED indicator illumi-
nated red. Then, when the power on/off but-
ton on the remote control or the channel
selector Up (/\) button or Down ( V )button
of the TV set is pressed, LED indicator will
turn green and a picture will appear on the
screen. The channel programme number is
also displayed in the upper right corner of the
Red/green/orange power screen. Press the power on/off button'((!)| )
and On-Timer indicator on the remote control to return the set to
standby mode (LED indicator will be illumi-
nated red, and also when the On-Timer is set,
ea cee the LED indicator will be illuminated orange.
CCl] See How to Set the On-Timer on page @.)
Note:
If the main power on/off button on the TV is
pressed (set to on), even the set has been
turned off previously with the remote control
unit's power on/off button, the TV will remain in
the standby mode, and no picture will appear.
Therefore, to make the picture appear on the
screen, press the power on/off button ( | ) on
the remote control or channel selector Up (/\)
button or Down ( V) button of the TV set.
Gysap
@ Sound volume V -— /A
The volume can be adjusted by pressing a
wa 00000------- volume button on the set or on the remote
Down <— —» Up
control. Press the Volume Up (/\) button to
increase the volume and the Volume Down
'(V)) button to decrease the volume. The
volume level is indicated. by the number of
rectangles, "@---" displayed after the " sf "
in the upper part of the screen. (Only the
" is displayed when there is
no sound.)