Pioneer SPH-EVO98DAB Installation Manual page 17

Factory radio-mounting bracket
If the pawl interferes with
installation, you may bend it down
out of the way.
Dashboard or console
Binding head screw (5 mm × 8 mm) /
Flush surface screw (5 mm × 8 mm)
Be sure to use the screws supplied
with this product.
2
Fasten the LCD screen mounting
bracket to the main unit at the suitable
position.
Depending on the vehicle, the front-
back position of the LCD screen may
need to be adjusted to mount it. Use the
supplied spacer ( ) if you choose the
front position to install the LCD screen.
LCD screen mounting bracket
Binding head screw (4 mm ×
30 mm)*
Spacer
* When using the back position to install
the LCD screen without using the supplied
spacer, use the binding head screws (4 mm
× 6 mm).
TIP
The mounting left-centre-right position of
the LCD screen mounting bracket can be
changed depending on the vehicle or
installation location of the main unit.
3
Detach the monitor cover from the
LCD screen ( ), then connect the
monitor cables to the LCD screen ( ).
After that, attach the LCD screen with
adjusting the up-down position ( ) to
this unit by using the screws each side
( ).
Push the monitor cables as far as
possible in this product before
attaching the LCD screen.
CAUTION
Insert the connector with the connector
projection ( ) side facing up. If you force
to insert the connector in upside down, it
may be broken.
Example: SPH-EVO107DAB
Monitor cover
Binding head screw (4 mm × 12 mm)
Connector projection
4
Secure the monitor cables to the hook
on the back of the LCD screen then
attach the monitor cover ( ) by using
the screws ( ).
Example: SPH-EVO107DAB
Monitor cover
Machine screw (2 mm × 4 mm)
NOTES
• Do not twist or bend the cables in
excess when securing the monitor
cables to the hook on the back of the
LCD screen.
• Be careful not to lose the small screws
(2 mm × 4 mm) for attaching the
monitor cover.
• It is recommended that you use a
magnetic screwdriver when attaching
the monitor cover.
• Two spare screws (2 mm × 4 mm) for
attaching the monitor cover are
included.
• When attaching the monitor cover
( ), tilt the LCD screen moderately
toward the front to facilitate
installation.
Installing the Floating model
(SPH-DA97DAB)
1
Move the joint on the chassis side
forward and backward to decide on a
position for the monitor ( ). After
deciding on a position in the forward/
backward direction, tighten the
screws at the top and bottom ( ).
Binding head screw (4 mm × 6 mm)
TIP
The following steps describe the procedure
when the monitor is pulled out by 20 mm.
However, the installation method is the
same regardless of the position to which
En
17