NuWave OXYPURE ZERO E 2000 Quick Start Manual

General Filter Cleaning Tips
1. Always Wear a Mask and Use Rubber gloves.
Prevents accidental inhalation of any contaminants when cleaning
your filters.
2. Move the OxyPure, Not the Filters
Minimizes filter shaking.
3. Handle the Filters Carefully
Be careful not to agitate the filters to avoid releasing trapped
contaminants.
4. Dry the Filters Completely
Never install a wet or damp filter into your OxyPure.
To Clean the Ozone Emission Removal Filter
1. Remove the filter. If possible, take them outside to clean.
2. Gently, but thoroughly, clean the filter using a brush-tipped vacuum.
3. Repeat the process on the other side. DO NOT GET WET.
To Clean the Stainless-Steel Prefilter
The Prefilter needs to be cleaned at least once every two months,
depending on use.
1. Use a brush-tipped vacuum to remove any dust or lint.
Cleaning the Odor Sensor
1. The Odor Sensor is the three slots located below the left-side handle
of the Oxypure. The Odor Sensor may ONLY be cleaned using a
brush-tipped vacuum.
Note: If you are unable to close the Filter Access Panel for any
reason, the OxyPure will not operate and you will need to contact
NuWave Customer Service. Exercise caution to ensure the
tabs are not damaged when securing the Filter Access Panel.
OXYPURE® ZERO E 2000
TM
©2023 NuWave LLC • All Rights Reserved.
®
Item: BQ47601 • Rev.1-V1-JD • 11-06-23
For Amazon Purchases: support@nuwavenow.com ● For All Other Purchases: help@nuwavenow.com
Cleaning the Dust Sensor
The Dust Sensor is located on the back of
the unit.
1. Open the Dust Sensor Cover.
2. Using a dry cotton swab, gently remove
any dirt or dust from the Dust Sensor.
3. For more buildup on the Dust Sensor,
wipe it with a slightly wet cotton swab.
4.
Remove any moisture with a dry cotton
swab.
NOTE: Consult the OxyPure Owner's Manual
for more detailed cleaning instructions.
Do not immerse the OxyPure in water.
Clean the outside of the unit with a damp
sponge or cloth and wipe it dry. Make
sure all parts and covers are securely
attached.
Do not dry the filters in direct sunlight or
with a blow dryer.
Open
Customer Service:
4
3
2
1