7 Place the card in the connector and press down firmly. Ensure that the card
is fully seated in the slot.
3
2
1
1 alignment bar
4 alignment guide
8 Replace the support bracket (see "Replacing the Support Bracket" on
page 173) and then press down the card retention bracket to seat it on its slot.
9 Ensure that:
•
The guide clamp is aligned with the guide notch.
•
The tops of all cards and filler brackets are flush with the alignment bar.
•
The notch in the top of the card or filler bracket fits around the
alignment guide.
2
fully-seated card
5
bracket within slot
4
3
not fully seated card
6
bracket caught outside of slot
Removing and Installing Parts
5
6
131