Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Osmofilter Blue Mountain High
Summary of Contents for Osmofilter Blue Mountain High
- Page 1 User’s manual...
-
Page 3: Table Of Contents
INDEX USER MANUAL PRESENTATION E INTRODUCTION | ¿WHAT IS REVERSE OSMOSIS? WATER QUALITY WATER POLLUTION : PRIOR WARNINGS TECHNICAL DATA OF THE SYSTEM : DETAILS OF THE ACCESSORY LIST PARTS OF THE SYSTEM PRE-INSTALLATION WARNINGS | SYSTEM INSTALLATION FILTERS CHANGE MAINTENANCE TROUBLESHOOTING WARRANTY... -
Page 4: User Manual
USER’S MANUAL Reverse osmosis membrane pore: 0,0001 microns Virus: 0,2 to 0,4 microns Bacteria: 0,4 to 1 microns Figure 1 Reverse osmosis is the reversal of the natural flow of osmosis. In the water purification system, the goal is to dilute the salt solution but separate the pure water from the salt and other contaminants. -
Page 5: Water Pollution : Prior Warnings
USER MANUAL 4. WATER POLLUTION period of time, turn off the power switch, discon- nect the power plug from the mains and discon- nect it from the mains. Environmental water is increasingly contaminated by waste from domestic, agricultural, and industrial Never use organic liquid to clean the machine. -
Page 6: Parts Of The System
USER MANUAL • 6. TECHNICAL DATA OF THE SYSTEM: 7. PARTS OF THE SYSTEM • • Model: Blue Mountain High. • Voltage / Frequency: 220/240V 50/60Hz. • Inlet power: 520W. • Heating power: 420W. • Cooling power: 100W. • Cold water capacity: 4,6 L. -
Page 7: Pre-Installation Warnings | System Installation
USER MANUAL 9. INSTALLATION WARNINGS covers on the back of the machine until the machine fills with water, just to clean the water The water source must be disconnected electrica- dispenser. lly during the entire installation. DO NOT turn on the hot water switch until the NOTES: second filling is done to avoid breakage in them resistor. -
Page 8: Filters Change
USER MANUAL 11. HOW TO MAKE FILTER REPLACEMENT 1. As shown in the picture, open the lower front panel of the machine. 2. Disconnect the blue locker. Press the ring into the joint and stretch the PE pipe. 3. Remove the old filter and replace it with a new one. -
Page 9: Maintenance
MAINTENANCE 12. SYSTEM MAINTENANCE It is important that your equipment is serviced by an official equipment service, which will use original spare parts and offer you a maintenance contract and a service guarantee. Any manipulation of the equipment or use of a non-ori- ginal spare part by a company or person other than our distributors will invalidate the warranty of your equipment, as well as that of your official distributor. -
Page 10: Troubleshooting
TROUBLESHOOTING PROBLEM RESOLUTION The following situations can be handled by ourselves. If it cannot be solved, please ask professional mainte- nance personnel for help to carry out thorough inspec- tion and maintenance. It is normal for the machines to make a slight noise during operation. PROBLEM POSITION SOLUTION... -
Page 11: Warranty
WARRANTY CUSTOMER INFORMATION: THE GUARANTEE DOES NOT EXTEND TO: Mr. / Mrs: Replacement, repair of parts caused by wear, due to normal equipment use, such resins, Address: polyphosphates, sediment cartridges, etc..as ZIP Code and location: indicated in the instruction manual of the Phone number: equipment. -
Page 12: Equipment Installation Log
EQUIPMENT INSTALLATION LOG NOTICE: Read this manual carefully. If you have any Clearly inform about the use, handling and questions, please contact the technical support maintenance required by the equipment to ensure service (T.S.S.) of your distributor. The data marked proper operation of water. -
Page 13: Technical Data
SYSTEM CONTROL AND MONITORING NOTICE DATE TECHNICAL DATA Name: Installation Signature or stamp: Maintenance Warranty Inspection Repair Name: Installation Signature or stamp: Maintenance Warranty Inspection Repair Name: Installation Signature or stamp: Maintenance Warranty Inspection Repair Name: Installation Signature or stamp: Maintenance Warranty Inspection... - Page 14 SYSTEM CONTROL AND MONITORING NOTICE DATE TECHNICAL DATA Name: Installation Signature or stamp: Maintenance Warranty Inspection Repair Name: Installation Signature or stamp: Maintenance Warranty Inspection Repair Name: Installation Signature or stamp: Maintenance Warranty Inspection Repair Name: Installation Signature or stamp: Maintenance Warranty Inspection...
- Page 16 WATER DISPENSERS...
Need help?
Do you have a question about the Blue Mountain High and is the answer not in the manual?
Questions and answers