Using A Cd/Dvd-Rom Drive - eMachines etower Series User Manual

Hide thumbs Also See for etower Series:

Table of Contents

Using a CD/DVD-ROM Drive

To insert a CD/DVD into the CD/DVD-ROM drive, first turn on your system. Then

press the load/eject button to open the disc tray. When the disc tray pops out, the busy

indicator light will flash. Put the CD/DVD in the tray with the label side up. Press the

load/eject button again or gently push the disc tray to close it.

When you want to remove the CD/DVD, make sure the busy indicator is off; then

press the load/eject button. When the CD/DVD tray pops out, remove the CD/DVD

and then press the button again to close the tray.

CD/DVD-ROM disc

Notes

When your system is turned off, you may need to open the CD/DVD

tray. At this time, insert a fine rod such as an opened paper clip into the

emergency eject hole as far as it will go. When the tray is slightly open,

carefully pull it out.

You computer calls the CD/DVD-ROM drive D unless you have more

than one hard disk drive or partition. Then it automatically recognizes

it as the next available drive letter.

Using Your Computer

3-3

Table of Contents

Do you have a question about the etower Series and is the answer not in the manual?