Advertisement
Quick Links
Advertisement
Subscribe to Our Youtube Channel
Related Manuals for Mennekes AMTRON Professional
Summary of Contents for Mennekes AMTRON Professional
- Page 1 Troubleshooting ENGLISH „ Troubleshooting procedure „ Error messages and solution approaches...
- Page 2 Troubleshooting work in which the charging station has to be opened may only be performed by a qualified elec- trician. For charging stations that comply with calibration law, the following applies: Work on components that are subject to calibration law may only be performed by a certified service technician. Otherwise the charging station is no longer compliant with calibration law.
-
Page 3: Troubleshooting Procedure
Error correction suc- cessful? Perform a function test with the MENNEKES test box Function test passed? Note down the article / serial number The charging station is ready for opera- and contact MENNEKES support tion again... - Page 4 Error messages and solution approaches „ The most common error messages are listed below. There may be error messages that are not listed here. „ The error messages are dependent on the firmware version. The error messages described in this document refer to firmware version 5.12.0.
- Page 5 Replace charging cable. wiring issue „ Wrong wiring of CP and PR. f Perform a function test with the MENNEKES Vehicle signals error The vehicle signals an error (status E) or the charging cable was not detected. test box.
- Page 6 Error message Cause(s) Solution approaches f Check networking. Not all DLM Slaves Disturbed communication bet- connected ween DLM Master and DLM Slaves. FW Update in pro- Firmware update. f Wait until the firmware update has been executed. gress Firmware update The firmware update could f Repeat the firmware download.
Need help?
Do you have a question about the AMTRON Professional and is the answer not in the manual?
Questions and answers