Seagate Exos X 4006 Series Instructions

Hide thumbs Also See for Exos X 4006 Series:

Download this manual

Replacing a 5U enclosure drive module in its carrier

This document contains the steps in replacing a drive module in its carrier for a 5U enclosure. More detailed information

is found in the Hardware Maintenance and Installation Guide (HMIG) for the Exos X 4006 Series storage systems and AP

Integrated Storage Servers. You can find the documents located at

systems.

DDIC – Disk Drive in Carrier

1. Complete the following actions to open the related drawer:

a. Facing the front of the storage enclosure, determine which drawer has a fault condition by the fault LEDs on

the ops panel and drawer panels.

b. If the anti-tamper lock is engaged, use a T20 Torx driver to unlock both pull handles on the drawer.

c. Simultaneously press both drawer latches inward and hold them there while exerting even outward pressure

until all three rows are visible and the drawer slide latch locks in the open position.

d. Stop when the drawer rails engage the safety lock latches as the drawer reaches the open position, so that you

can access all three rows of DDICs.

2. Complete the following actions to remove a faulty DDIC:

a. Locate the DDIC with a fault condition.

Exos X 4006 Series and AP Integrated Storage Servers

https://www.seagate.com/support/data-storage-

Need help?

Do you have a question about the Exos X 4006 Series and is the answer not in the manual?

Page 1 This document contains the steps in replacing a drive module in its carrier for a 5U enclosure. More detailed information is found in the Hardware Maintenance and Installation Guide (HMIG) for the Exos X 4006 Series storage systems and AP Integrated Storage Servers.
Page 2 b. Using a thumb, press the DDIC release latch arrow to the right to release the DDIC from its seated position. c. Grasping the top of the carrier, pull it upwards until it clears its drawer slot. Removal of the DDIC d.
Page 3 4. Complete the following actions to close the related drawer: a. Press and hold the safety lock latches with the blue touchpoint at the front of both extended drawer slide rails. b. Pressing simultaneously inward, begin sliding the drawer back into place until the safety lock clears the opening.