Inserting Batteries - Minolta DIMAGE 2300 - AUTRE Manual

INSERTING BATTERIES

The Minolta Dimâge 2300 uses four AA-sized alkaline batteries.
• You may also use AA-sized Ni-Cd or Ni-MH batteries.
• When using Ni-Cd or Ni-MH batteries, fully recharge them with a vendor-endorsed
battery charger.
When replacing the batteries,
move the lens cover slide to
to turn the camera off.
Open the battery/card-chamber
door by sliding it in the direction
indicated, then open the door.
Insert the batteries as indicated
by the +/- diagram on the back of
the battery/card-chamber door.
• You may skip this step when inserting the
batteries for the first time after purchase.
- 18 -
While pulling up the battery/card-
chamber door slightly, fold it
down and slide it slightly toward
the front of the camera.
Then, while using a downward
pressure, slide it back to the rear
of the camera until it clicks.
After replacing the batteries, check that the clock in the camera (date and time) is
correct (see pages 109 - 113).
Especially, when the AC adapter is unused and the battery/card-chamber door
remains opened more than 10 minutes, the clock in the camera may delay or be
reset to the default setting. If this occured, set the date and time accurately
according to the directions described on pages 109 - 113.
- 19 -
INSERTING BATTERIES