Performance AXIOM Owner's Manual page 5

Mounting the Computer
1
The sensor sh
the sensor approximately halfway up the fork blade, but do not tighten yet.
Mount the magnet to a spoke directly opposite the sensor. Line up the magnet so
that it is centered
spoke magnet screw, taking care not to overtighten it. See Diagram 2.
2
The distance between the magnet and the sensor should be 2 mm or less. Once the
sensor is positioned properly and centered on the magnet, pull the cable ties
tight. Recheck the sensor for proper alignment.
Route the cable upward (either winding it around the fork blade or laying it in a
2 mm
straight line on the outside of the fork blade). Wind the cable around the front
brake cable. Be sur
3
interfere with the handlebar movement. Secure th
cable ties.
Note: Do not route the sensor cable along lighting wires/cables. This may cause
the computer to not function properly.
Secure the mount to your handlebars, usin
Diagram 3.
4
Slide the computer forward into the mounting unit until it snaps into place with
an audible "click" (Diagram 4). To check proper function, activate the computer
by rotating the front wheel. The current speed display should show a reading. To
remove your computer from its mount, depress the tab underneath the unit and
slide it towards you.
ould be m oun ted to th e right f ork blad
between the top and bottom lin
e to leave suffi cien t slack so that the computer cable will not
g a rubber shim if n
e. Using th e cable ties, mount
es on the sensor. Tigh ten the
e cable to your f ork blade with
ecessary. See