Performance AXIOM Owner's Manual page 3

Wired
Initial Set Up
Your Axi om 5.0 will compute distan
battery the kilometer (km/h) and mile (m/h) symbols will alternately be displayed. When the desired measur-
ing unit is displayed (i.e. km/h or m/h), press the gray button. The wheel circumference value of 2124 (or
your latest wheel circumference setting) will then be displayed.
If you already know your wheel circumference g
Determining Wheel Circumference
Programming Wheel Circumference and Odometer
When you know your wheel circumference, you are ready to program your wheel circumference into your
computer.
If th e computer is in th e wheel circumference setup mode go to
paragraph down).
If you are not in wheel circumference setup mode, press the gray button until the ODO, odometer, is dis-
played on the screen. Press the gray button for two seconds, the kilometer (km/h) and mile (m/h) symbols
will alternately be displayed. When the desired measuring units are displayed (i.e
gray button.
The wheel circumference value o
If the wheel circumference value shown is correct, press the gr
setup mode.
If you must change the wheel circumference value, wait two seconds and the right digit will begin to
increase. When the correct digit is displayed press the gray button, the next digit will automatically begin
changing. Repeat this process until all four digits display the correct wheel circumference. In the miles
mode, on ce completed you will be out o
If you are using kilometer mode, the odometer, ODO, m
programmed, the odom eter will be sh
or, if the ODO reading is correct, press the gr
Note 1: You cannot program the odometer, ODO, in miles mode.
Note 2: Your Axiom computer has the ability to easily convert miles into kilometers and vice versa. After
you configure your initial settings, you may switch measuring units at any time. Press the gray button until
press the gray button twice and you will have converted units in your computer.
Cyclocomputer
ce and speed functions in eith
o to - Programming Wheel Circumference
f 2124 (or your latest wh eel circumference settin
ay button within 2 secon
f setup mode.
ay be pr ogrammed. Once the wheel circumference is
own. Program th e ODO in the same manner as the wheel circumference
ay button six tim es to e
er miles or kilom eters. After in stalling the
, otherwise g
The wheel circumference value ...
. km/h or m/h), cli
g) will be displayed.
ds to complete
xit set up m ode.
o to -
(forth
ck the