Table of Contents
Advertisement
72
Adding Parts
Insert the module straight down into the connector, ensuring that it
3
fits into the vertical guides at each end of the connector. Press firmly
on the ends of the module until it snaps into place.
If you insert the module correctly, the securing clips snap into the
cutouts at each end of the module.
Close the computer cover (see page 72).
4
Attach the computer stand (optional) (see page 16).
5
NOTICE:
To connect a network cable, first plug the cable into the network
wall jack and then plug it into the computer.
Connect your computer and devices to electrical outlets, and turn
6
them on.
Right-click the My Computer icon and then click Properties.
7
Click the General tab.
8
To verify that the memory is installed correctly, check the amount of
9
memory (RAM) listed.
Ensure that all cables are connected, and fold cables out of the way.
1
Make sure cables are not routed over the drive cage—they will prevent
the cover from closing properly.
Ensure that no tools or extra parts are left inside the computer.
2
Pivot the cover down and ensure that the release buttons click into
3
place.
Attach the computer stand (optional) (see page 16).
4
NOTICE:
To connect a network cable, first plug the cable into the network
wall jack and then plug it into the computer.
Connect your computer and devices to electrical outlets, and turn
5
them on.
Advertisement
Table of Contents
