Frymaster LOV-T Quick Start

LOV-T Quick Start:
A: M4000: Programmable
for automatic filtering.
Press (YES) button to
respond YES to filter
prompt.
C: Filter Pan
NOTE: The Frymaster LOV-T
fore normal restaurant operations can begin.
B: Power switch: One in cabinet under each
controller (not shown domestic electric only).
fryer requires a start-up, demonstration and training be-
1. Fill vats with oil/ shortening to lower fill line.
2. Turn on power switches if applicable (B).
3. Turn controllers on by pressing and holding the
button for two seconds.
4. Controller (A) displays "CHANGE FILTER PAD? YES/
NO".
5. Press  (YES) and controller displays "REMOVE PAN".
6. Remove filter pan (C) and controller displays "CHANGE
FILTER PAD".
7. Change filter and reassemble filter pan, ensuring pan is
out 30 seconds. Re-install filter pan.
8. Position oil/shortening container in the right cabinet,
placing pick-up tube in open container (E).
9. Press and hold the top off reset switch until yellow indi-
cator goes out on controller. (D).
10. A "P" indicates the filter pan is not properly placed. Re-
seat the filter pan if necessary.
11. While cooking, respond YES to the Filter Now prompt in
display (A) by pressing the  (YES) button.
12. Respond to the empty oil container yellow indicator light
by replacing the oil/shortening container (E) and reset-
ting the top off reset switch (D) or refilling the oil con-
tainer with bulk oil system.
E: Oil/Shortening Container: Holds
oil/shortening for automatic top-off
system. It's not used to fill the vats,
just to maintain the oil level. Use only
fresh oil in top off system.
D: Top off reset button: Press and
hold after replacing the oil/shortening
until yellow indicator goes out.
819-7538 02/2025