Advertisement
INSTALLATION AND WIRING INSTRUCTIONS
AMPLIFIER MODULE
Mount the amplifier module in a location that is conveniently accessible to the rear speaker
wiring harness. It is these wires the RB-3600 interrupts. It is not necessary to mount the
amplifier module close to the television. Connect one end of the 10-pin cable assembly to the
amplifier module.
Cut the wires to the rear radio speakers. Connect the rear speaker(s) as follows:
Left rear speaker(s)
Left rear speaker(s)
Right rear speaker(s)
Right rear speaker(s)
The optional interface harness, that is available for some vehicles, will simply plug into the
OEM speaker harness. No cutting/splicing is necessary.
Connect the dash radio rear amplifier outputs as follows:
Left rear amplifier
Left rear amplifier
Right rear amplifier
Right rear amplifier
Connect 12 volt power to the RB-3600 as follows:
+12 volt power
Ground
Connect the Audiovox television external speaker output to the RB-3600 as follows:
External speaker output
External speaker output
Unplug the audio output of the VCP. Connect the isolation transformer as follows:
Isolation transformer male RCA : to VCP audio output
Isolation transformer female RCA : to RCA cable that was plugged into the VCP
+
: white wire on 4-pin connector
-
: violet wire on 4-pin connector
+
: blue wire on 4-pin connector
-
: green wire on 4-pin connector
+
: gray/white wire on 8-pin connector
-
: gray wire on 8-pin connector
+
: brown/white wire on 8-pin connector
-
: brown wire on 8-pin connector
: red wire on 8-pin connector
: black wire on 8-pin connector
+
: pink blue wire on 8-pin connector
-
: black/white blue wire on 8-pin connector
Theater Sound System
Advertisement
