Table of Contents
Advertisement
6. Press the Disc button and the printer tray comes out. If the tray does not come
out, go to page
7. Manually rotate the leadscrew counterclockwise to lower the picker down to the
printer tray. The leadscrew can only be rotated if the picker motor is not
energized. Do not press the operator button on the autoloader! If the leadscrew
cannot be rotated, refer to
If the printer tray was moved during the alignment, you must run the tray in and
out again.
8. If the picker fingers are not centered over the hole of the disc, alignment is
necessary.
Installation
31
for help.
"Releasing Picker Motor
28
Energy" section on page 31.
Advertisement
Table of Contents
