Install Liberty Printer Driver - Rimage CDPR3 Installation And User Manual

9. Connect the printer power cord from the autoloader to the printer.
10. Check all the cable connections as shown in the picture below. Remember, do NOT
power on the Desktop system until instructed.
11. Connect all remaining cables to the monitor, mouse, keyboard, and the AC power cords.
12. If your system came with a PC, go to
13. Go to the "Install Liberty Printer
1 – Firewire Cable
2 – Autoloader
3 – Printer Power Cord
4 – USB Cable

Install Liberty Printer Driver

To install the Liberty Printer Driver, you must be logged on as a member of the
Administrators group. Do not install the Liberty Printer Driver with the printer powered
on! Install the driver before the printer is powered on. Do not install the Rimage OfficeNet
Software Suite until instructed!
Make sure the system is powered off by the Power Switch on the autoloader. If the
Liberty printer was connected to the PC and powered on when the PC started, reboot
the PC.
To install the printer driver on Windows XP, go to page 17.
To install the printer driver on Windows 2000, go to the next section.
Installation
"Install Ink
Driver" section next.
5 – Liberty Printer
6 – Autoloader Control Cable
7 – Autoloader Control Cable
8 – Serial Port (not used)
1 – AC Power Switch - OFF
14
Cartridges" section on page 22.
9 – AC Power Switch
A – AC Power Cord