Advertisement
Quick Links
Advertisement
Subscribe to Our Youtube Channel
Related Manuals for Uponor Smatrix D+RH T-247 BUS
Summary of Contents for Uponor Smatrix D+RH T-247 BUS
- Page 1 Uponor Smatrix Base thermostat D+RH T-247 BUS Operation manual CD0000789...
-
Page 2: Table Of Contents
Troubleshooting after installation.......... 11 Flash-illuminated alarm symbols........... 11 Digital thermostat alarms/problems........11 Speak to the installer............12 Installer instructions.............. 13 Technical data..............14 Technical specifications............14 Performance curves.............. 14 Dimensions................14 Uponor Smatrix Base thermostat D+RH T-247 BUS Operation manual... -
Page 3: Copyright And Disclaimer
For any questions or queries, please visit the local Uponor website or speak to your Uponor representative. “Uponor” is a registered trademark of Uponor Corporation. -
Page 4: Preface
• Do not use water to clean electrical Uponor products/ components. Uponor is not liable for damage caused by ignoring the instructions in this document or the applicable building code. Uponor Smatrix Base thermostat D+RH T-247 BUS Operation manual... -
Page 5: System Description
Uponor website: www.uponor.com. CD0000776 The Uponor Smatrix Base thermostat D+RH T-247 BUS comes with a big LED display and capacitive keys. The capacitive keys and the front glass make cleaning of the front of the thermostat easy. -
Page 6: Operation
Relative humidity measured with seconds timeout period, the thermostat will display the "not paired" the RH sensor icon ( ). After a few seconds, it will return to run mode, displaying the main screen. Uponor Smatrix Base thermostat D+RH T-247 BUS Operation manual... -
Page 7: Main Screen
When you press the OK button, the display switches from the main screen to the humidity measurement screen. • After 10 seconds of inactivity, the display will automatically return to the main screen. Uponor Smatrix Base thermostat D+RH T-247 BUS Operation manual... -
Page 8: Digital Thermostat Functions
4.6 Digital thermostat functions Run mode The thermostat is in run mode during normal operation. The display turns off after 20 seconds of inactivity and can only be reactivated by pressing a button. Uponor Smatrix Base thermostat D+RH T-247 BUS Operation manual... - Page 9 Heating/cooling changeover If the setback temperature is set to 0, the thermostat will remain This menu is not visible if the thermostat is registered to a Uponor unaffected if a program sets the system in ECO mode. Smatrix Base Pulse controller.
-
Page 10: Factory Reset
This menu is only visible if control mode RFT is activated in settings menu 04. For systems with a communication module, this menu only shows the set value Changes can be made in the Uponor Smatrix Pulse app. See Change the settings, Page 9 , for how to change the setting. -
Page 11: Troubleshooting
This section describes general problems and alarms that can occur with the Uponor Smatrix system and gives solutions for them. Problems are frequently caused by loops that are installed incorrectly or by thermostats that are in the incorrect room or that are registered The display remains inactive after incorrectly. -
Page 12: Speak To The Installer
Defective temperature sensor Note – Make sure that the remote sensor is connected correctly. Relative humidity control is activated in the Uponor – Disconnect the remote temperature sensor and examine it Smatrix Pulse app (requires communication module). with an ohmmeter. Make sure that the value agrees with the •... -
Page 13: Installer Instructions
If the loop becomes warm, the cause can be the room control system. A supply system malfunction can be identified by no warm water in the manifold. Do a check of the boiler and circulation pump. Uponor Smatrix Base thermostat D+RH T-247 BUS Operation manual... -
Page 14: Technical Data
The full text of the EU/UK declaration of conformity is available at the following internet address: https://www.uponor.com/doc/1071651 1) Refer to the related Uponor product for the specified certification and compliance marks. Additional product information and instructions are delivered with the Uponor product. - Page 15 Uponor GmbH Industriestraße 56, D-97437 Hassfurt, Germany Uponor reserves the right to change the product portfolio and the 1145510 v1_01_2025_EN related documentation without prior notification, in line with its policy of www.uponor.com Production: Uponor / SKA continuous improvement and development.
Need help?
Do you have a question about the Smatrix D+RH T-247 BUS and is the answer not in the manual?
Questions and answers