Page 5
1.2 Declaration of conformity Hilti hereby declares that the radio equipment type PS 85 is compliant with Directive 2014/53/EU. The complete text of the EU declaration of conformity has been posted on the Internet here: qr.hilti.com/manual/?id=2327817 Safety 2.1 General safety instructions, measuring tools...
Page 6
▶ Do not under any circumstances modify or tamper with the product. Changes or modifications not expressly approved by Hilti may restrict the user’s authorization to operate the product. ▶ Check the accuracy of the measuring tool before using it for important measurements, and if it has been dropped or subjected to other mechanical stresses.
Page 7
▶ Due to the measuring principle employed, the results of measure- ments can be negatively affected by certain ambient conditions. These include, for example, the proximity of devices that produce strong magnetic or electro-magnetic fields, vibrations and temperature changes. ▶ Rapidly changing measuring conditions can falsify the results. ▶...
Page 8
▶ Check the accuracy of the measuring tool if it has been dropped or subjected to other mechanical stresses. If the measuring tool is damaged, have it repaired by a Hilti service center. ▶ The specified operating and storage temperatures must be observed.
Page 9
Observe the special guidelines applicable to the transport, storage and use of lithium-ion batteries. Read the instructions on safety and use of Hilti Li-ion batteries that you can access by scanning the QR code at the end of these operating instructions.
▶ When replacing batteries, make sure that the correct procedure is followed. There is a risk of explosion. ▶ Do not attempt to recharge button-cell batteries and do not short- circuit button-cell batteries. The button-cell battery can develop a leak, explode, catch fire and injure persons. ▶...
• Consult the dealer or an experienced TV/radio technician for assistance. Changes or modifications not expressly approved by Hilti may restrict the user’s authorization to operate the equipment. This device complies with the requirements set out in Paragraph 15 of the FCC rules and fulfills the requirements defined in RSS220 in combination...
Page 12
§ 2.405(a) through (e) of this chapter, is followed by the UWB equipment user. Responsible party Hilti, Inc. 7250 Dallas Parkway, Suite 1000 US-Plano, TX 75024 www.hilti.com For users in Canada: This radar imaging device shall be operated only where directed toward the floor or wall, and where it is in contact with or at a distance of 20 cm from the floor or wall surface.
Page 13
shall be operated only by law enforcement agencies, scientific research institutes, commercial mining companies, construction companies, and emergency rescue or fire-fighting organizations. English...
Need help?
Do you have a question about the PS 85 and is the answer not in the manual?
Questions and answers