aidapt VP186 Fixing And Maintenance Instructions page 6

ADJUSTING THE HANDLE HEIGHT
• To adjust, loosen the adjustment screw on the handle by turning it counter clockwise until it can
be removed (fig. 20).
• Adjust height to desired height (fig. 21), reinstall the adjustment screw by turning it clockwise
until it is tight (fig. 22).
fig. 20
ADJUSTING THE PAD HEIGHT
• To adjust, loosen locking lever located under the pad, remove the locking pin.
• Adjust pad to desired height and then reinstall locking pin, secure in place with retainer tab.
• Tighten the locking lever to lock pad in place.
FOLDING TILLER
To fold the tiller, release the tiller-locking handle and slide assembly to the side until tiller is disengaged.
Fold tiller down until it rests on the pad and release locking mechanism.
CAUTIONS
• Please contact your provider if any parts are loose or show excessive wear.
• Do not operate on loose gravel or uneven surfaces.
• Do not travel over large cracks or fissures.
• Move forward slowly when encountering cracks or separations is walkway surfaces.
• Do not operate in excess of 3 miles per hour.
• Do not turn unless one foot is on the ground.
• Do not turn at high speeds.
• Do not operate on incline about 15 degrees.
• Do not travel over drop or curbs.
• This product is not a toy.
• Always check fasteners on the tiller, wheels, brakes and pad for tightness before use.
• Adjust steering mechanism to the correct height .
• Do not sit, stand or lean on steering mechanism.
• Steering mechanism is not weight bearing.
fig. 21 fig. 22