Cisco 8712-MOD-M Manual

Replace Chassis Components
Note
Caution
•
•
•
•
Replace Modular Port Adapters
The following sections describe how to remove or install an MPA:
Remove a Modular Port Adapter
Before you begin:
Use one of the following procedures to perform graceful shutdown of the card:
• unscrew the captive screws, pull the release latch, and open ejector lever to trigger auto-shutdown of the
• use the shutdown location location command in admin EXEC mode to shutdown the card. Then use
To remove an MPA, perform the following steps:
1. Perform the graceful shutdown of the MPA. Run the shutdown location location command in admin
EXEC mode, which gracefully shuts down MPA to prevent any of the file systems from being corrupted.
The images in this chapter are only for representation purposes, unless specified otherwise. The chassis' actual
appearance and size may vary.
Whenever you replace any card, you must always ensure to secure the ejector thumbscrews properly.
Replace Modular Port Adapters, on page 1
Replace Blank Cards, on page 4
Replace Fan Modules, on page 5
Replace Power Supply, on page 7
card, and then verify that the Status LED is in Off state (The LED status transitions from Green to Red
and Off which takes up to 5 seconds).
the show platform command to verify that the Status LED is in Off state.
Replace Chassis Components
1