Page 1
Electric Ride-On Toy Excavator User Manual [Revision 5.0 February 2019] READ THIS MANUAL CAREFULLY BEFORE USE AND KEEP FOR FUTURE REFERENCE – FAILURE TO DO SO MAY RESULT IN INJURY, PROPERTY DAMAGE AND MAY VOID WARRANTY. • Products covered by this manual may vary in appearance, assembly, inclusions, specifications, description and packaging.
Electric Ride-On Toy Excavator Safety Read and understand all safety warnings and instructions before assembling or using the electric ride-on car ("toy"). The instructions not only specify the assembly process and proper operation, but also help you to avoid injuries or damaging the product due to incorrect operation. Choking hazard –...
Electric Ride-On Toy Excavator • Thermal Fuse - The toy is equipped with a built-in thermal fuse. The fuse is a self-resetting safety device that shuts down the toy if it is overloaded. Once a fuse has tripped it will automatically reset after approximately 10 seconds and allow the toy to resume normal operations.
Electric Ride-On Toy Excavator • Batteries can fall out and cause injury if the toy overturns. Always use the battery brackets and cover (seat). • Batteries must be upright while charging – ensure the toy is sitting on a flat surface when being charged. •...
Electric Ride-On Toy Excavator Parts Identification Identify all parts before assembly and save all packaging material until assembly Is completed to ensure that no parts are discarded. • Metal parts may be coated with lubricant for protection during shipment. Wipe all metal parts with a paper towel to remove any excess lubricant. • Assemble the toy according to instructions.
Electric Ride-On Toy Excavator Assembly Children may be harmed by small parts, sharp edges and points or electrical components when the toy is not assembled. Video Tutorial: Care should be taken to not allow children near parts when unpacking Typical Ride-On Car Assembly and assembling the toy.
Page 8
Electric Ride-On Toy Excavator 5. Install the windscreen. • Align the tabs at the bottom of the windscreen (O) with the slots in the main body. Carefully push the windscreen down so it is properly located by the tabs/slots and "clips" into place. 6.
Page 9
Electric Ride-On Toy Excavator 7. Connect the battery. Firmly push the unconnected battery wire (Z) onto the free battery • terminal (AA). Once connected, the battery can be charged using the toy charging port. 8. Install the seat (this also acts as a battery cover). Ensure no wires can be crushed or pinched when the seat is installed.
Electric Ride-On Toy Excavator Operation Controls When operating the excavator arm, if the arm reaches the limit of travel and the control continues to be held, the toy will "click". Avoid holding the controls once the excavator arm has reached its limit of movement as wear or damage to the arm mechanisms may result.
Electric Ride-On Toy Excavator Name Description Secondary Front Secondary lighting for the roof. Insert batteries into the housing to use the lights. Lights Light ON/OFF switch included. Driver Mode Operation 1. Ensure the "driver" is correctly and safely seated in the toy and the seat belt is buckled. 2.
Electric Ride-On Toy Excavator Name Description Used to move the toy in the forward direction. Press and hold as required. Forward Used to move the toy in the reverse direction. Press and hold as required. Backward Direction Used to set toy direction. Rotate left or right and hold as required. Note that when the button is released, the toy wheels do not automatically return to centre.
Electric Ride-On Toy Excavator Troubleshooting Malfunction Analysis Solution Toy moves in reverse Drive motors connected Swap the toy wiring harness to drive motor assembly direction to controls incorrectly. connections. Toy not running or was Direction control in remote Ensure that direction control is not in centre position (remote running but suddenly control mode.
Electric Ride-On Toy Excavator Maintenance • If the toy is damaged, do not use it until it is repaired at an authorised service centre. • An adult should inspect the toy at regular intervals for wear or loose hardware and tighten as required. Do not use the toy if abnormal conditions such as cracks or breaks exist.
Page 17
Electric Ride-On Toy Excavator Some experts believe the incorrect or prolonged use of almost any product could cause serious injury or death. For information that may reduce your risk of serious injury or death, consult the points below and additionally, the information available at www.datastreamserver.com/safety •...
Need help?
Do you have a question about the Digger and is the answer not in the manual?
Questions and answers