Radio Frequency Interference; Safety Warning - NEC VERSA S5500 Series User Manual

The equipment has been approved in accordance with Council Decision 98/482/EC for pan-European single
terminal connection to the Public Switched Telephone Network (PSTN). However, due to differences
between the individual PSTNs provided in different countries, the approval does not, by itself, give an
unconditional assurance of successful operation on every PSTN network termination point.
In the event of problems, you should contact your equipment supplier immediately.

Radio Frequency Interference

The manufacturer is not responsible for any radio or TV interference caused by unauthorised modifications to
this equipment.

Safety Warning

The manufacturer is not responsible for any safety hazard caused by unauthorised modifications to this
equipment.
WARNING
: Changes or modifications to this unit not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment.
Note: This is a Class B Digital Device. This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to CISPR22 Standard. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates, uses and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause
harmful interference to radio communications.
There is no guarantee, however, that interference will not occur in a particular installation. If this equipment
does cause harmful interference to radio or television reception, which can be determined by turning the
equipment on and off, the user is encouraged to try to correct the interference by one or more of the
following measures.
Reorient or relocate the receiving antenna.
Increase the distance between the equipment and receiver.
Connect the equipment to an outlet on a circuit different from the one to which the receiver is
connected.
To meet CISPR22 Standard, shielded cables and power cords are required when connecting this device to a
personal computer or other Class B certified device.
- 9 -