Correcting The Bootmagic Configuration - NEC POWERMATE VT 300 - RELEASE NOTES Release Note

Correcting the BootMagic Configuration

If you installed BootMagic in a system with the Windows NT operating system
and the installation resulted in an error message, use the following procedure to
correct the configuration information.
1. In the Windows Start menu, select
and BootMagic Configuration
Nothing should be listed under the MENU NAME heading in the center of
the box.
2. Click
ADD
listed and it is already highlighted.
3. Click
OK
appears with "Windows NT" listed under MENU NAME.
4. Check the BootMagic configuration.
T
If you want to use BootMagic:
Click the
during the next bootup sequence and lets you select Windows NT as the
operating system.
T
If you do not want to use BootMagic:
Do not select the
does not appear at bootup.
5. Select
enable BootMagic or to not enable BootMagic, requires the SAVE/EXIT
selection.
To correctly complete the BootMagic configuration, you must
select SAVE/EXIT from the BootMagic Configuration box,
even if you do not want to use BootMagic. Omitting this step
results in an error message.
. The "Bootmagic Add OS" box appears. This is the only option
. Click again. The main BootMagic Configuration screen
OK
ENABLE BOOTMAGIC
ENABLE BOOTMAGIC
SAVE/EXIT in the BootMagic Configuration box. Either choice, to
! CAUTION
NEC PowerMate VT 300 Series Release Notes 15
,
Programs PowerQuest BootMagic
. The BootMagic Configuration box appears.
button. The BootMagic menu appears
button. The BootMagic menu
,