EINHELL AQUINNA 36/30 Set Operating Instructions Manual page 21

To ensure that the battery pack provides long ser-
vice, you should take care to recharge it promptly.
You must recharge the battery pack when you
notice that the performance of the device drops.
Never allow the battery pack to become fully di-
scharged. This will cause it to develop a defect.
5.5 Battery capacity indicator (Fig. 4)
Press the button for the battery capacity indicator
(Item A). The battery capacity indicator (Item B)
shows the charge status of the battery using 3
LEDs.
All 3 LEDs are lit:
The battery is fully charged.
2 or 1 LED(s) are lit:
The battery has an adequate remaining charge.
1 LED fl ashes:
The battery is empty, recharge the battery.
All LEDs blink:
The battery temperature is too low. Remove the
battery from the equipment, keep it at room tem-
perature for one day. If the fault reoccurs, this me-
ans that the rechargeable battery has undergone
exhaustive discharge and is defective. Remove
the battery from the equipment. Never use or
charge a defective battery.
6. Operation
6.1 On/Off /Pump setting switch (Fig. 1/Item 5)
Switch position 0: Off
Switch position I: Pump setting 1
Switch position II: Pump setting 2
Important!
Selecting pump setting 2 increases the maximum
delivery pressure, but it reduces the maximum
operating time of the battery as a result.
6.2 Using for the fi rst time
•
Install the equipment on a solid and level
surface.
•
Fill the pump housing with water via the
water filler screw (3). Filling the intake line will
accelerate the priming process.
•
All the shut-off devices in the discharge
line (spray nozzle, valves etc.) must be fully
opened during intake in order to permit all air
to escape from the intake line.
Anl_AQUINNA_36-30_Set_SPK13.indb 21 Anl_AQUINNA_36-30_Set_SPK13.indb 21
GB
•
The intake process starts automatically after
you have pressed the On/Off/Pump setting
switch (5). Water can be suctioned in for up to
5 minutes (maximum suction height).
•
If the pump is removed after use, it is
essential that it is filled with water again the
next time it is connected and started.
Switch the pump off again after use by pressing
the On/Off /Pump setting switch (5) again and al-
low the pump to cool down.
7. Cleaning, maintenance and
ordering spare parts
The equipment almost completely maintenance
free. In order to ensure a long service life,
however, we recommend regular checks and
product care.
Danger!
Always remove the batteries before starting any
cleaning work.
7.1 Maintenance
•
If the equipment becomes clogged, connect
the discharge line to the water line and
disconnect the intake line. Open the water
line. Switch on the equipment several times
for approx. two seconds. This should resolve
the majority of clog-related problems.
•
There are no other parts inside the equipment
which require maintenance.
7.2 Ordering replacement parts:
Please quote the following data when ordering
replacement parts:
•
Type of machine
•
Article number of the machine
•
Identification number of the machine
•
Replacement part number of the part required
For our latest prices and information please go to
www.Einhell-Service.com
- 21 -
29.05.2024 08:30:38 29.05.2024 08:30:38