SJE Rhombus In-Site EZ Series Installation And Operation Manual

With sub-x lt or c-level sensor
Hide thumbs Also See for In-Site EZ Series:

Advertisement

Available languages

Available languages

Control Panel
For information regarding operation,
?
available options, or servicing
questions, please call SJE Rhombus
Technical Support.
Manufactured by:
SJE Rhombus
Detroit Lakes, MN, USA
EZ Series
with SUB-X
C-Level
Installation and Operation Manual
US Patent Nos. 10,251,284 B2; 8,336,385;
SUB-X
LT or
C-Level
Sensor
This control panel must be installed and serviced by a licensed electrician in
accordance with the National Electric Code NFPA-70, state and local electrical codes.
UL Type 4X enclosures are for indoor or outdoor use.
SJE Rhombus o ers a ve-year limited warranty on the control panel
and a two-year limited warranty on the SUB-X™ LT or C-Level™ sensor.
For complete terms and conditions, please visit www.sjerhombus.com.
Products returned must be cleaned, sanitized, or decontaminated as necessary
prior to shipment to ensure that employees will not be exposed to health
hazards in handling said material. All applicable laws and regulations shall apply.
Technical Support: +1 800-746-6287
techsupport@sjerhombus.com
www.sjerhombus.com
Sensor
8,567,242 and 8,650,949
Recommended
High Alarm Float
Warranty void if panel is modified.
EZ Series
In-Site
®
LT or
Redundant O Float
®
®
EN1

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the In-Site EZ Series and is the answer not in the manual?

Questions and answers

Summary of Contents for SJE Rhombus In-Site EZ Series

  • Page 1 UL Type 4X enclosures are for indoor or outdoor use. Warranty void if panel is modified. SJE Rhombus o ers a ve-year limited warranty on the control panel and a two-year limited warranty on the SUB-X™ LT or C-Level™ sensor.
  • Page 2: Mounting The Control Panel

    Mounting the Control Panel Install top fastener using appropriate anchor. Install bottom fastener(s) using appropriate anchors. Installing the SUB-X LT or C-Level Sensor & Recommended Float Switches ™ ™ The EZ Series ® In-Site ® CL control panel operates with a SUB-X™ LT or C-Level™ sensor and 1 or 2 recommended oat switches. The SUB-X™...
  • Page 3 SUB-X™ LT or C-Level™ Sensor Sensor Positioning Float Switch Positioning CAUTION! If the SUB-X ™ LT sensor, C-Level ™ sensor or oat switches are not mounted and connected correctly, the pumps and alarm will not operate properly. Stow excess tube using a cable tie.
  • Page 4: Wiring The Control Panel

    If redundant o oat is not used, a jumper must be NOTE installed in its place. gases from entering into the control panel. PN 1064580E 02/25 © 2020 SJE, Inc. All Rights Reserved. SJE RHOMBUS is a trademark of SJE, INC.
  • Page 5 SJE Rhombus ofrece una garantía limitada de cinco años en el panel de control Para información acerca del y una garantía limitada de dos años para el sensor SUB-X™ LT o sensor C-Level™.
  • Page 6 Montaje del panel de control Instalar el(los) soporte(s) inferior(es) con la ayuda del Instalar el soporte superior usando el anclaje apropiado. anclaje apropiado. y de los interruptores de fl otador recomendados Instalación del sensor SUB-X LT o sensor C-Level ™ ™...
  • Page 7 Posicionamiento del sensor SUB-X™ L T o sensor C-Level™ Posicionamiento del interruptor de nivel PRECAUCIÓN Si no se realiza el montaje y la conexión correctos del sensor SUB-X ™ LT o sensor C-Level ™ de los interruptores de otador, ni las bombas ni la alarma van a funcionar bien.
  • Page 8: Confi Guración Y Operación

    Si no se usa un otador de apagado redundante, en NOTA de gases o humedad al panel de control. su lugar debe instalarse un puente. PN 1064580E 02/25 © 2020 SJE, Inc. Reservados todos los derechos. SJE RHOMBUS es una marca registrada de SJE, INC.
  • Page 9: Manuel D'installation Et D'utilisation

    SJE Rhombus o re une garantie limitée de cinq ans sur le panneau de contrôle et une garantie limitée de deux ans sur le sonde SUB-X LT™ ou sonde C-Level™. Pour plus de détails sur le Pour en savoir plus au sujet des termes et conditions, visitez notre site à...
  • Page 10: Installation Du Panneau De Commande

    Installation du panneau de commande Installez la xation supérieure à l'aide d'un ancrage Installez la ou les xations inférieures à l'aide d'un approprié. ancrage approprié. et des interrupteurs à fl otteur recommandés Installation de la sonde SUB-X-LT ou sonde C-Level ™...
  • Page 11 Positionnement de l’interrupteur à fl otteur Positionnement de la sonde SUB-X L T sonde ou C-LEVEL™ ATTENTION Si la sonde SUB-X LT ™ ou sonde C-Level ™ ou les interrupteurs à otteur ne sont pas montés et connectés correctement, les pompes et l'alarme ne fonc- tionnent pas correctement.
  • Page 12: Installation Et Fonctionnement

    Si vous n'utilisez pas de otteur d’arrêt redondant, l'humidité ou les gaz de pénétrer dans le REMARQUE panneau de commande. installez un cavalier à la place. PN 1064580E 02/25 © 2020 SJE, Inc. Tous droits réservés. SJE Rhombus est une marque déposée de SJE, Inc.

Table of Contents