Control Panel Buttons - NEC C Manual

Control panel buttons

To use control panel buttons, monitor and computer power must be
on. See the following figure to locate the monitor control panel
buttons.
the monitor. When the lamp is red, the monitor is on, but it
is not getting a signal (either because the signal cable is
not connected or the computer is not on). When the lamp is
green, the monitor is on and is receiving a signal. When the
lamp is orange, the monitor is in power management mode.
Use control panel buttons to bring up the OSD menus and adjust
monitor settings.
Note:
The power lamp shows the operating state of
Locating control panel buttons
Adjusting the monitor 15