Connect The Monitor - NEC C Manual

Connect the monitor

Your NEC C Series monitor has a signal cable and a power cable that
need to be connected to your computer and a power source.
Use the following steps to connect the signal and power cables.
computer to locate the monitor connector on the computer.
1.
2.
3.
6 Setting up your monitor
Note:
See the documentation that comes with your
Make sure your computer is powered off.
Connect the signal cable (see the following figure).
T
Remove the protective cap from each connector on the
signal cable.
T
Locate the connector marked with a
Carefully align the connector with the VGA video port on
your computer and plug it into the port. Tighten the two
connector screws.
T
Carefully align and plug the other connector into the rear
of your monitor. Tighten the two connector screws.
Connect one end of the power cable to the monitor and the
other end to a properly grounded power outlet.
C (for computer).