Kohler KALLISTA P31426-00-BV Installation Manual

Record your model number below CAUTION: Risk of personal
for future reference: injury.
Do not install where the product might
be used as a grab or support bar.
3 Single-Post Accessories: 4 Drywall Into Studs:
Position the wall plate and mark the Drill 1/8" holes. Secure the wall
holes. Verify plumb. plate(s).
1288202-2-A
Important Information Recommended Tissue Holder
Location
These products should be located and
mounted to a wall stud. While it is
possible to mount them to any surface,
a stud mounted product will yield the
best results.
Drywall Between Studs: Ceramic Tile:
Drill 5/16" holes. Use the provided pin Drill 1/4" holes. Insert ceramic anchors.
to install the drywall anchors. Secure Secure the wall plate(s).
the wall plate(s).
1
2
3
4
1
Two-Post Accessories:
Verify "X" against the measurements
of your product model.
P25043: 18" (457 mm)
P25041: 24" (610 mm)
X
8" (203 mm) –
12" (305 mm)
X
6"
(152 mm)
5 For All Accessories:
Slide the accessory onto the post(s).
Tighten the setscrew(s).
1/8"
2
For All Installations:
Loosen the setscrew and remove the
wall plate from the accessory.
X
1/4" 5/16"