Output Power : Less than Class 1 For CD Wave length : 785 - 795 nm Output Power : Less than Class 1 LABEL CHECK The following caution appears on your unit. HTZ-121DVD/LXE, HTZ-121DVD/TWXE Location: inside of the unit DCS-222K/YXE8 (Printed on the Rear Panel) HTZ-121DVD...
Compared with eutectic solders, lead-free solders have higher bond strengths but slower wetting times and higher melting temperatures (hard to melt/easy to harden). The following lead-free solders are available as service parts: • Parts numbers of lead-free solder: GYP1006 1.0 in dia. GYP1007 0.6 in dia. GYP1008 0.3 in dia. HTZ-121DVD...
Tuner • Power requirements: • FM Tuning Range: AC 110 V to 240 V, 50 Hz/60 Hz (HTZ-121DVD/LXE) 87.5 MHz to 108.0 MHz AC 220 V, 50 Hz/60 Hz (HTZ-121DVD/TWXE) AC 220 V to 240 V, 50 Hz/60 Hz (DCS-222K/YXE8) Amprifier •...
• HD DVDs • AVCHD • AVCREC • DVD-Audio discs • DVD-RAM discs • SACDs • CD-G • Discs recorded with packet writing • Programs that can be recorded only once and that are (already) recorded on a DVD-R/-RW/-R DL HTZ-121DVD...
• The filename of the movie file has to extension “.avi”. be repeated at the beginning of the filename for the external subtitle file. • The number of external subtitle files which can be switched for the same movie file is limited to a maximum of 10. HTZ-121DVD...
Page 9
• This Player supports ID3 tag Ver1.1. • The order of the folder and file names displayed on the Disc Navigator is dependant on the time and date when the folders or files were created on the USB device. HTZ-121DVD...
DivX®, DivX Certified® and associated logos are trademarks of Rovi Corporation or its subsidiaries and are used under license. This product includes technology owned by Microsoft Corporation and cannot be used or distributed without a license from Microsoft Licensing, Inc. HTZ-121DVD...
Cleaning Be sure to clean the following positions by using the prescribed cleaning tools shown below as occasion demands. Position to be cleaned Name Part No. Remarks Pickup leneses Cleaning liquid GEM1004 Refer to “7. DISASSEMBLY”. Cleaning paper GED-008 HTZ-121DVD...
Service Remote Control Unit GGF1381 Service Mode DVD Test Disc (DVD-Video,NTSC) DVD Test Disc (DVD-Video,NTSC) GGV1025 GGV1025 Diagnosis Diagnosis DVD Test Disc (DVD-Video,PAL) GGV1101 Diagnosis STD-905 CD Test Disc Diagnosis Speaker cable for AMP output check GGP1199 AMP Check HTZ-121DVD...
MAIN BOARD ASSY is normal Replace MAIN BOARD ASSY Check the FRONT BOARD ASSY signals VSCLK,VSDA,VSTB Check the connect line is OK (XP3:pin10,pin11,pin12) Check whether the circuit connected to K135,K136,K137, Correct connection K138,K139,K140 are broken. Replace K135, K136, K137,K138,K139,K140 HTZ-121DVD...
Check whether the remote Replace the battery for remote controller’s battery is controller exhausted or not Check the IR601(HT68F50) power supply is OK, Check the VCC line(net) on FRONT BOARD ASSY IR601 : pin3 is about 3.3V Replace FRONT BOARD ASSY HTZ-121DVD...
Check the control signal at U182 : Replace U182 on MAIN BOARD ASSY, pin10 and pin11 on MAIN BOARD ASSY or replace MAIN BOARD ASSY and the signal at XP11 : pin9 and pin10 whether right or not Replace AMP BOARD ASSY HTZ-121DVD...
Check the loader whether Check XP3 on MAIN BOARD ASSY work normally or not Check the XP2(24pin), XP4(6pin) and Fix XP2(24pin), XP4(6pin) XP3(5pin) cable from MAIN BOARD and XP3(5pin) cable ASSY to Loader whether connect right or not Replace Loader HTZ-121DVD...
Page 22
(pin3,pin4 : I2C intput) whether Change Tuner Module normal or not Check the U182 (pin35, Check the U182 power supply circuit pin36 : I2C output) on MAIN BOARD on MAIN BOARD ASSY ASSY whether normal or not Replace MAIN BOARD ASSY HTZ-121DVD...
Page 23
Check R436 and C270 on MAIN BOARD ASSY whether normal or not Check the R341,R342, Check the U33(74HC4052) whether C160 and C162 on MAIN BOARD ASSY broken or not whether normal or not Replace MAIN BOARD ASSY Replace MAIN BOARD ASSY HTZ-121DVD...
Page 24
Check the Q4 power supply and out U33(74HC4052) : pin16(MO_VCC) circuit on MAIN BOARD ASSY on MAIN BOARD ASSY whether normal or not Check the U33(74HC4052) Check U20 on MAIN BOARD ASSY whether broken or not Replace MAIN BOARD ASSY HTZ-121DVD...
Page 25
U33(74HC4052) : pin16(MO_VCC) Check the Q4 power supply and out on MAIN BOARD ASSY whether circuit on MAIN BOARD ASSY normal or not Check the U33(74HC4052) whether Check U20 on MAIN BOARD ASSY broken or not Replace MAIN BOARD ASSY HTZ-121DVD...
Page 26
10) HDMI does not output HDMI does not output Check the signal at P3 on MAIN Replace P3 BOARD ASSY whether normal or not Check the voltage at P3 : pin18 Replace FB15 (HDMI_VCC) whether right or not Replace MAIN BOARD ASSY HTZ-121DVD...
-2 : NG 7.0e -4 : NG 3 EDC/ID error history (ID Address, EDC/ID errors, last eight errors) Indication plan contents Note: ∗ Error of AV1 is not supported in this player. Character in bold : Item name : Information display HTZ-121DVD...
Page 28
• Indication of model information (ESC + CHAP keys) To display model information, press the CHAP key while holding the ESC key pressed. To quit, press the ESC key. MODEL NAME: HTZ-121DVD/LXE MPEG_VERSION : V** MCU_NAME: MCU_300_OTHER_V** REGION: ** MODEL NAME...
If the Tray is unlocked, slide it out by hand. • Bottom view [2] Front Cabinet Section (1) Release the jumper wires from the Binder. (2) Disconnect the two connectors (XP5, XP12) from the MAIN BOARD ASSY. XP12 MAIN BOARD ASSY HTZ-121DVD...
Page 30
AMP BOARD ASSY (1) Remove the two screws on the rear side. (64-B30040-304) (2) Remove the screws on the rear side. [ HTZ-121DVD: two screws ] [ DCS-222K: three screws ] (63-B30070-3H4) MAIN BOARD ASSY [ Case of DCS-222K ]...
Page 31
Bottom Plate. FRONT BOARD ASSY Bottom Plate (3) Reverse MAIN BOARD ASSY and AMP AMP BOARD ASSY BOARD ASSY and allocate each unit as shown in the photo. (4) Insert the insulation sheet. Insulation Sheet MAIN BOARD ASSY HTZ-121DVD...
Page 32
Styling of cables between units Caution 1: When you attach each unit, make a styling and connection of cables as shown in the photo. Caution 2: Nothing should be connected to the connector part surrounded by red line. HTZ-121DVD...
Page 33
FFC Holder located at bottom side of the Loader ASSY. (4) Remove the two screws. (5) Remove the two screws and then remove the Chassis Traverse. Front FFC Holder Loader ASSY (bottom side) Hook HTZ-121DVD...
Page 34
Cleaning liquid : GEM1004 Cleaning paper : GED-008 Pickup Lenses Caution: The pickup is a high-precision component; therefore, clean the lens with enough care so as not to cause a misalignment in the optical axis. Chassis Traverse pick-up portion HTZ-121DVD...
Page 35
(3) Please remove solder at protection point to the arrow-mark direction by using soldering iron with your right-hand while holding the pick-up portion with your left-hand after the completion of all mounting. (Photo shows the situation after the removal of solder) protection point HTZ-121DVD...
Then by pressing PLAY key on Remote Control Unit, "UPG - MCU" is displayed on FL tube and the upgrade starts. It takes about 5 minutes by finishing upgrade. Notice: Please don't interruption the power supply and extraction USB during upgrading. 4. After upgrading successful, the system will standby. HTZ-121DVD...
Page 37
You can confirm model information by pressing ESC + CHAP keys on Service Remote Control Unit. If you upgraded incorrect MCU software, please upgrade correct MCU software again. Model Name MCU NAME DCS-222K/YXE8 MCU_300_EU_V** HTZ-121DVD/LXE MCU_300_OTHER_V** HTZ-121DVD/TWXE HTZ-121DVD/AXQ5 HTZ-120DVD/DXERB HTZ-121DVD/DXECS HTZ-222DVD/LXE...
But the software for service is only MPEG Software. 2. Changing the Destination Setting 1 At the Pioneer Logo screen, press OPEN/CLOSE button. 2 With Tray open, press AUDIO button and press the numeric buttons 1, 2, 3, then 4, in that order, on the supplied Remote Control Unit.
Page 39
You must upgrade both MPEG Software and MCU Software. Be sure to write the latest Software that suits the destination of the product, because the product will not operate properly with the Software for service, which is used for changing the Destination Setting. HTZ-121DVD...
Screws adjacent to b mark on product are used for disassembly. For the applying amount of lubricants or glue, follow the instructions in this manual. (In the case of no amount instructions, apply as you think it appropriate.) 9.1 PACKING SECTION DCS-222K /YXE8 only HTZ-121DVD/LXE, DCS-222K/YXE8 only HTZ-121DVD/TWXE only HTZ-121DVD...
Page 41
3920V-0019A 22 SPEAKER ASSY SUB-WOOFER SMX1128-W 23 Soft Bag MAF62208304 24 Packing Top Bottom 3920V-0002A (2) CONTRAST TABLE HTZ-121DVD/LXE, HTZ-121DVD/TWXE and DCS-222K/YXE8 are constructed the same except for the following: HTZ-121DVD/ HTZ-121DVD/ DCS-222K/ Mark No. Symbol and Description TWXE YXE8 >...
9.2 EXTERIOR SECTION DCS-222K/YXE8 only HTZ-121DVD/LXE, HTZ-121DVD/TWXE only HTZ-121DVD...
Page 43
46-KK011C-24AU 13 FFC 20pin 300mm 46-KK030C-20BV 14 Cushion 54-103870-000 NSP 15 AC inlet 46-KL018T-03XD (2) CONTRAST TABLE HTZ-121DVD/LXE, HTZ-121DVD/TWXE and DCS-222K/YXE8 are constructed the same except for the following: HTZ-121DVD/ HTZ-121DVD/ DCS-222K/ Mark No. Symbol and Description TWXE YXE8 2 MAIN BOARD ASSY...
NC/10K NC/10K TROUT R156 R156 NC/1K NC/1K USB power without control MotorDriver ASSY POWER ON,VCC_USB having TRIN R166 R166 POWER OFF,VCC_USB having not C193 C193 C192 C192 NC/5PIN/2.0mm NC/0.1uF/25V/Y5V NC/0.1uF/25V/Y5V 0.1uF/25V/Y5V 0.1uF/25V/Y5V XP6 for TDL-5 XP3 for TDM-3 2PIN/2.0mm HTZ-121DVD...
0.47uF/63V 0.47uF/63V 2PIN/7.92mm 2PIN/7.92mm 2.2M 2.2M CN501 ZD503 ZD503 100K 100K BZX79C11 BZX79C11 R526 R526 * CAUTION : THE PARTS MARKED WITH ARE IMPORTANT PARTS ON THE SAFETY. PLEASE USE THE PARTS HAVING THE DESIGNATED PARTS NUMBER WITHOUT FAIL. HTZ-121DVD...
11. PCB CONNECTION DIAGRAM 11.1 MAIN BOARD ASSY SIDE A MAIN BOARD ASSY HTZ-121DVD...
Page 69
1. The parts mounted on this PCB include all necessary parts for several destinations. For further information for respective destinations, be sure to check with the schematic diagram. 2. View point of PCB diagrams. Connector Capacitor SIDE A SIDE B P.C.Board Chip Part XP12 XP501 HTZ-121DVD...
Need help?
Do you have a question about the HTZ-121DVD and is the answer not in the manual?
Questions and answers