Accessing The Cd-Rom Reader; Replacing The Front Panel - NEC DIRECTION T Manual

Replace the front panel (see "Replacing the Front
12.
Panel").
Replace the access cover (see "Replacing the Access
13.
Cover").

Accessing the CD-ROM Reader

If you need to access the CD-ROM reader, you need to
remove the side cover on the minitower or the accessible
device cage on the desktop.
For the minitower, press the side cover in and slide it
toward the rear of the system. If it is tight, insert a
screwdriver into the slots between the cover and the front
panel and carefully pry it loose.
For the desktop, use the following procedure to remove the
accessible device cage.
Locate the screw and tab at the upper left of the device
1.
cage and the tab on the lower left.
Locate the two tabs at the lower rear and two on the
right side of the system unit.
Remove the screw securing the cage.
2.
Slide the cage toward the front of the system until it
3.
releases from the system. The tabs may need to be
pressed to release the cage.

Replacing the Front Panel

To replace the front panel, follow this procedure.
Align the front panel's six tabs with their corresponding
1.
slots on the system (three of the tabs have holes, the
others have prongs).
2. Press the front panel squarely into position until the tabs
lock the panel in place.
5-32 Installing Options