Making Basic Calls; Starting A Call; Correcting Mistakes; Ending Calls - NEC D400 Manual

Table of Contents

Making basic calls

You make a simple call in the same way as you would with a normal phone, except that you need to press the

phone number and area STD code. To make international calls you must first enter the international dialling code (see page 9).

Open the Flip (if necessary) and key in the phone number. Check the number on the display.

Use the full STD area code even if you are in the same town. Long numbers will continue on a second line.

Press

to send the call.

If you do not wish your number to be displayed on the phone you are calling, turn the send own number feature off (see page 8).

To abort the call at any time, press

will be displayed.

The display will show you that the system is trying to connect your call and changes as you hear the call established.

When the call is connected the screen displays the number called or your name for the number (if a name has been stored in memory along

with the number - see page 30), the duration of this call so far (if the in-call timer feature is enabled - see page 21), and the signal strength.

Use the

key to to scroll through the number then press C to clear individual digits or hold down the C key to

completely clear a phone number.

Press

(Short press) or close the Flip (if the Flip option is active - see page 3). The phone returns to standby.

If the call cannot be connected, you will hear a tone. The display will give an appropriate message, and the phone will return to standby. If

your phone is set to Autoredial the number will be automatically called again after a short delay (see page 21).

If a connection is broken, such as by a poor radio signal, then the phone returns to standby. You may also get a warning tone.

briefly or close the Flip (if the Flip option is active - see page 3). The Standby screen

key after entering the